Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

light-colored, machinable wood to go w Cherry-----

Posts

light-colored, machinable wood to go w Cherry-----

#1

light-colored, machinable wood to go w Cherry-----

ronster15------WebKitFormBoundaryYukplFdFRMs+31yy

>I need to select a light-colored wood for the 3 inside sides of a bunch of drawers. Drawer fronts will be cherry, which I already have stockpiled. Bottoms will be baltic birch. I had originally planned on poplar sides, though the green hues sometimes bother me, because it's cheap and easy to work with.

I now see that "soft maple" can be had for not much more $. But I have no experience with it.

I'm doing machine cut dovetails on a basic (porter cable) 12 inch jig. About 20 drawers so I need to buy a bunch of whatever I go with.

Will this soft maple have worse tear out than poplar? Will it's color be more complementary?

thanks,

ron

------WebKitFormBoundaryYukplFdFRMs+31yy

Re: light-colored, machinable wood to go w Cherry-----

#2

Go with the soft maple. You'll like it

Tom Rex in TX

>

Re: light-colored, machinable wood to go w Cherry-----

#3

Agree. Could Also Use Birch

George@Colonel's Workshop-Havertown PA

>

Re: light-colored, machinable wood to go w Cherry-----

#4

Re: light-colored, machinable wood to go w Cherry-

Dave Bair, Eaton Rapids, MI

>It would be a good use for that sapwood I always seem to have plenty of whenever I buy a bundle of cherry.

Re: light-colored, machinable wood to go w Cherry-----

#5

Bart Goldberg

Another idea - Sapele!

Bart Goldberg

>

Re: light-colored, machinable wood to go w Cherry-----

#6

Re: Go with the soft maple. You'll like it

AZ, Colorado Springs

>Go with the maple

Re: light-colored, machinable wood to go w Cherry-----

#7

Re: light-colored, machinable wood to go w Cherry-

Jesse Cloud

>Maple and cherry is a classic combination. I use it a lot.

Maple might tear out a little more than poplar, which is just about the easiest wood to work there is. Can you use a backer board on your dovetail jig (shift it or replace it often)? Also, try to avoid lots of figure where you will be cutting the dovetails. Look for nice straight grain at the lumberyard. Also, don't leave 1/2 maple stock around too long, it will want to warp. I suggest milling it close to when you will be cutting the joinery. Once the joinery is cut, go ahead and assemble your drawers, don't leave it sitting around - the drawers will come together much easier!

Re: light-colored, machinable wood to go w Cherry-----

#8

green poplar is fleeting

Bill Tindall, E.TN

>10 min in the sun and the green is gone for ever and replaced by brown. The same will happen in the drawer, just slower.

But, soft maple is a very nice wood, just more expensive.

Re: light-colored, machinable wood to go w Cherry-----

#9

Thanks all -- I'll try the maple!

ronster15

>