Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Built-in Bookcases

Posts

Built-in Bookcases

#1

Built-in Bookcases

Ed Freestone

>I'm planning a winter project of a wall of built-in bookcases and a window seat. I'm following the general design Norm used in his Library System; plywood carcasses with poplar face frames and trim - all painted to match the other woodwork in the bedroom. I know many of you have made similar things for customers or yourselves. I have two questions, at least to start.

We would like the bottom of each of the three bookcases to have a drawer rather than an open shelf. The drawers will be approximately 30"w x 12"d x 12"h.

1. Would plywood drawer boxes with solid wood fronts be aesthetically pleasing?

2. Would you use metal drawer slides or wood runners like you'd put in a table or dresser?

Re: Built-in Bookcases

#2

comment on drawer size

Bill Tindall, E.TN

>I don't have an opinion on your questions as it seems a personal preference, but a 12" deep drawer is a huge drawer. Perhaps you have something in mind to put in it but if not, then two smaller drawers could be more useful.

Re: Built-in Bookcases

#3

Re: Built-in Bookcases

Ed Mulligan, Cape Cod MA

>I'd use undermount full extension metal slides for that application.

Yes, solid wood drawer fronts would be nice. Somewhat easier to fit, no edging needed, painted texture will better match the painted wood face frames. MDF would also be a good choice.

Agree with Bill about the drawer size.

Re: Built-in Bookcases

#4

And I agree with Ed

Bruce, a MN Galoot

>a 12" drawer has the potential to carry a whole lot of stuff. All necessary, no doubt, but it's going to be heavy. Solid wood slides have two disadvantages:

1. they don't allow access to the back end of the drawer and

2. they don't move freely with so much stuff in them.

Ed and Bill are right.

Bruce

Re: Built-in Bookcases

#5

Here's what I did

Ken Krawford

>Ed,

I made a bookcase unit similar to what you're proposing. The drawers pictured are 14" deep and 18" wide. The bottom ones are 8" high and the top ones are 5". I used full extension drawer slides.

I'm not sure how a 30" x 12" drawer would look. At least consider how it would look to break the unit into multiple drawers.

Ken


img

Re: Built-in Bookcases

#6

Re: Here's what I did

Ed Mulligan, Cape Cod MA

>Nice job, Ken!

For Ed, another idea ... if you have to have the 12" high drawers, make the drawer front so it looks like two drawers (like Ken's).