Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Powder post beetle (and other insect) control??

Posts

Powder post beetle (and other insect) control??

#1

JL

Powder post beetle (and other insect) control??

JL

>Now that I have a larger stash of lumber, I would like to keep it "whole" and reasonably intact - until I want to cut it.

Which brings us to the realm of control against insects (particularly powder post (powderpost?) beetles). As I understand it, having kiln-dried wood is NOT a protection.

I don't know if I want to "inhale" Boracare or Timbor or whatever. I normally keep my wood indoors and stacked on my racks. This is going to change. I may end up keeping some of this lumber for years. In the past I have killed bugs on smaller pieces of lumber using "dry ice" in a garbage bag. The CO2 evidently suffocates them. Can't do this with big stacks.

So the question - how do you protect your lumber against insects?

Re: Powder post beetle (and other insect) control??

#2

Dale Lenz

Re: Powder post beetle (and other insect) control?

Dale Lenz

>If you don't see any evidence of powderpost beetles, I would not worry about them. Enjoy the wood.

Re: Powder post beetle (and other insect) control??

#3

Re: Powder post beetle (and other insect) control?

Barry Irby

>JL, funny you should ask. As a turner, I have sought out and turned numerous pieces of buggy wood. Pooh Poohed the idea that I was bringing insects into my shop. About six months ago I picked up two freshly cut holly short logs that would have a couple of nice bowl blanks in each. 14" in diameter and 16" long. Yesterday I noticed one of them has a bug hole in it. Wasn't there when I coated them. Hmmm?

If I wanted to keep the lumber a long time I think I would spray it with Bora Care. Boracare is much less toxic than the Lyndane they used years ago.

Or, go over to WoodWeb and read up on the topic.

Re: Powder post beetle (and other insect) control??

#4

Re: Powder post beetle (and other insect) control?

Doug Reynolds in Seattle

>I just learned from a lumber miller and internet supplier of turning blanks his method. Put the blanks in a plastic bag such as the large 33 gallon garbage bag. Give it a good squirt of carburetor clearner and seal the bag with a twist tie. He states the carburetor cleaner does not effect finish and is not harmful to humans after it flashes off. The man is a retired geneticist so, I assume he knows of what he speaks.

Re: Powder post beetle (and other insect) control??

#5

a VERY bad strategy

Bill Tindall, E.TN

>This question comes up regularly so it would be useful to get some information in the archives.

This lumber is going to live in my region so the experience we have in storing several thousand bdft of inventory over the years is relevant. So is the hundreds of dollars lost to these things.

In the past much lumber, especially lumber prone to stain, was treated with a chemical (a relative of pentachloro phenol) that killed fungus and these things. But it was banned and I don't see mills dipping packs in anything any more.

I have no idea what motivates these things but when they attack a board they can ruin it completely. And, for what ever reason, they may not touch lumber in an adjacent rack. I have never had a problem with them getting into poplar while they completely destroyed all of the sap wood and some of the heart wood in a 500 bd ft stack I sold someone. Given this unpredictability an ounce of prevention is prudent. Here is the sum of my experience:

They prefer sap wood but will penetrate into heart wood.

When they attack they can completely consume the sap wood and leave behind nothing but a few pin holes to the outside and dust within the shell of the board.

They can attack with little evidence on the outside of the board, just a few pin holes.

Ash seems to be a favorite food. We have had more problems with ash than anything. But, they have invaded walnut, cherry, oak. Never had a problem with maple, maybe because it was treated at the kiln with a stain prevention that also dissuades these things.

It could be years before they attack, or tomorrow.

I have never had them attack inside the shop. Only in outside storage.

I have never had an invasion in lumber sprayed with insecticide. I use Lindane.

Re: Powder post beetle (and other insect) control??

#6

not useful for prevention, but good for treatment

Bill Tindall, E.TN

>

Re: Powder post beetle (and other insect) control??

#7

Dale Lenz

I stand as stated!

Dale Lenz

>Assuming you are keeping the kiln dried wood inside, I don't see a reason. People have hardwoods in their home, and the bugs could find areas not finished to invade, does not seem to be a major problem.

I use Lindane myself on fresh cut lumber as I'm putting it up to dry. I believe Lindane will break down within a year, my lumber is dry before then.

Let's see:

You could heat the lumber up to 130*F something every few months to kill out any buggers.

Could spray with Lindane once or twice a year to kill any bugs coming or going.

Treat with BoraCare or Timbor should be good for life, should work, but I don't think it's necessary.

My assumption is the lumber mentioned was kiln dried and taken care of properly. Very rarely will I buy lumber "dried" from some "Mom and Pop" sawmill unless I know they handle their drying correct, including critter control.

Re: Powder post beetle (and other insect) control??

#8

Re: a VERY bad strategy

Randy Johnson Connersville IN

>Bill, I can't speak about lumber stored indoors but I can state beyond all doubt that powder post beetles WILL attack indoor wood. I done work in several old houses that had active ppb problems in floor joists. As a matter of fact, the first time I ever heard of the little critters was when I was 13 or so and an exterminator was showing the evidence of some of them to dad at my grandmother's house.

Granted, in all cases where I have seen damage it has been in older houses that might not be as tight as newer homes. However, I'm sure some of us have shops housed in older buildings as well. Doors and walls probably shouldn't as an absolute guarantee against powder post beetles.

Re: Powder post beetle (and other insect) control??

#9

clarification

Bill Tindall, E.TN

>This pictures show a plank of oak riddled by tunnels. There was scant evidence on the outside that this damage lay within. For this reason I don't suggest waiting till you see evidence of attack before treating the lumber. In my experience by the time you see evidence of attack much damage can be done.


img

Re: Powder post beetle (and other insect) control??

#10

Lindane is forever

Bill Tindall, E.TN

>I know from experience that Lindane will protect wood stored outside in air drying piles for at least 15 years. In fact EPA has largely banned this handy stuff because it is so persistent. It is water insoluble so it won't wash off and it is not readily degraded out in the environment. The borax stuff may be as good. I don't have any experience with it. However, I am quite certain that it will wash off. But, that may not an issue in a covered pile.

That said, my disagreement with your recommendation is that waiting till you see damage in a pile can mean that the damage is largely done by the time you observe it.

Re: Powder post beetle (and other insect) control??

#11

Dale Lenz

Re: So...

Dale Lenz

>Bill all of my information, which comes from State Extension publication and Lindane labels. For treating bark borers on trees you spray Lindane several time, weeks to a month or so apart during that growing season. There is bound to be some dilution, break down, or whatever. Seems to me you would only need to spray once, if the Lindane did not loose any of it's punch or maybe the Lindane crystal becomes unattached from the bark of the tree due to rain or something else.

I guess, in JL case, I would not bother spraying for PPB on dried wood, kinda like adding armor siding to your car in the US in case of a drive-by shooting. Now if JL puts the wood in an unheated shed with out a floor, all bets are off.

For the record, using air-drying piles for storage is not a good idea, dry the wood to 12-15% and get it indoors. I think the thought behind not using the drying piles as storage, is: It's a gamble. More likely to re-wet the lumber, cause wood surface checks, during storms, plus other environmental factors. Have read about luther's(sp?) air dry their lumber for 30 years before working it. Maybe they do, bet they have a hugh de-grade in their lumber, assuming they keep their supply outdoors.