vacuum pumps
Paul Woelper
>howdy everyone,Question? I'm looking for a vacuum pump but I dont know to much about them .What to look and not look for.Whats best for lathe applications.any suggestions?
Knowledge You Can Build On — Est. 1998
vacuum pumps
Paul Woelper
>howdy everyone,Question? I'm looking for a vacuum pump but I dont know to much about them .What to look and not look for.Whats best for lathe applications.any suggestions?
Re: vacuum pumps
Barry Irby
>You might get more response if you post this on the Turning forum. (On the right, below the messages forum.) There are several messages there with in the last few days. Go There a search the word Vacuum.
You might try the Joe Woodworker site. Not sure they promote the use of the pumps for vacuum chucking, may be more for vacuum veneering.
Re: vacuum pumps *LINK*
Mark Mandell - Gone Round In Jersey
>Paul,
Up to the time I moved my Stubby out of the basement, I used a pair of used dehumidifier compressors, hooked up in parallel, for my vacuum chucking rig. Worked great and cheap, too! You can see pics on the AAW forum site under the "How To" forum section.
I didn't have room in my new "turning studio" [the garage] for the old set up so I bought a rebuilt Robinair 6 CFM vacuum pump from A&A in Ohio (see link - then go-to Robinair) for under $200 delivered. VERY nice and VERY quiet. Pulls 26" and has enough airflow to compensate for leakage which is very important for lathe work as opposed to veneering rigs.
Highly recommend A&A. Call and ask for Dan McGivern. His brother Bernie (Jr.) is a turner who used to run the division, but has moved on. Nice guys.
A&A