Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

OT Question on Paint grade doors?

Posts

OT Question on Paint grade doors?

#1

OT Question on Paint grade doors?

Barry Irby

>Another question for the masses. Looked at some custom made paint grade doors today. The panels were MDF. The edges of the panels were ragged and fuzzy. There were many other minor dents, chips, bulges, etc. The doors were delivered primed. The supplier claims that it is the responsibility of the painters to sand the doors and repair the defects. I think the doors should have been sanded and repaired before they were primed and that some of the defects should have been rejected during manufacture. What say you?

Re: OT Question on Paint grade doors?

#2

Re: OT Question on Paint grade doors?

John in NM

>Though I would not deliver a door in that condition and then pass the buck, I wouldn't expect the run of the mill supplier to do anything else. If the doors cost more than say $500 apiece, I'd expect the supplier to take a little more care and pride in their product, and probably wouldn't be shy about letting them know what I think of their attitude. But I'd still expect to have to have the painters fix the problems.

Re: OT Question on Paint grade doors?

#3

Jason Roehl in Lafayette, IN

Man...

Jason Roehl in Lafayette, IN

>...I was just getting comfy here after work, and you mention this? Are you trying to get me all worked up?

Between manufacturers and carpenters, I have had to fix a LOT of $#%$# over the years.

Personally, I don't care for the MDF doors. They're somewhat smooth, but there is an underlying undulation (bet you've never seen that particular alliteration) that just doesn't look right. I still make 'em look pretty good anyway.

Jason

Re: OT Question on Paint grade doors?

#4

Re: Man...

Barry Irby

>Jason, I am having a hard time wrapping my head around this. The millwork company that makes the doors primes them and then claims its the painters responsibility to go back and sand the rough edges off the MDF panels. And they were rough.

There were many other defects in these doors also, most of which could be fixed with Bondo and time, but it would have been a lot of time. They said and hour a door. Maybe?

There was a door in the house that came form Lowes. It was clearly better made than these doors. The panels and all the edges were crisp and there were no chips and knots. Could have just painted the door without any prep.

These were standard six panel doors.

I still can not "get" that the custom doors at $350 each were "better" than the door form Lowes for $100.

Re: OT Question on Paint grade doors?

#5

Clint Searl

You get what you pay for

Clint Searl

>