Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Expert advice on care of cordless tool batteries

Posts

Expert advice on care of cordless tool batteries

#1

Expert advice on care of cordless tool batteries

Bill Tindall, E.TN

>This information comes from a friend that leads a battery R&D group and I have confidence he knows about these things. I posed the following question and below it is his answer:

When one buys a tool it comes with two

batteries, say for this example two Li

batteries. Suppose one only uses the

tool occasionally. What is the best

strategy for getting the most life from

these two batteries?

Answer:

There is quite a variety in quality of Li-ion batteries. The better ones can be recharged over 500 times; the cheaper ones tend to lose their ability to be recharged. The answer to your question is to keep them partially charged. Detrimental degradation will occur if Li-ion batteries are left very fully charged, or completely discharged. Perhaps the worst condition of all is a truly 0 volts completely discharged battery. Keeping them at 1/2 - 2/3 charged is probably optimum. The great thing about these batteries is that you can recharge them whenever you want. Unlike Ni-Cd batteries there is no need to drain them completely before charging them.

Re: Expert advice on care of cordless tool batteries

#2

Re: Expert advice on care of cordless tool batteri

Barry Irby

>I have no Li battery tools. Had my batteries rebuilt several years ago and supposedly upgraded to NiMH rather than NiCd. More amp hours also. Can't say I have been impressed. The batteries run down on their own because they get occasional use. Some won't hold a charge over night. Paid over $200 to build four 12 volt batteries. They sure don't seem "better than new". I really like the tools. Hate the batteries.

A friend was just telling me that he runs his cell phone down every night and then puts it on the charger. I did not ask, but surely it is a Li battery.

I tend to leave the spare battery sitting in the charger. Wonder how that affects them? It's supposed to be a smart charger.

I was curious as to whether you would get more charges if you recharged it at 50% than if you ran it down? That is, if you run the battery all the way down and recharged it 500 times, could you recharge it 1000 times if you ran it down 50%?

Re: Expert advice on care of cordless tool batteries

#3

Re: Expert advice on care of cordless tool batteri

Tony - Memphis

>My company has a couple of hundred thousand Li batteries in our fleet. We try not to store batteries, but when they are delivered, they are typically at around 40% capacity. That's the level that seems to prolong the life when stored. Li likes to be topped off though. That's hard for people to get used to. I keep my Li batteries plugged in whenever possible. We shoot for around 400 charge cycles. Li cells are very temp. sensitive, so that number varies quite a bit. There are lots of variables. And even after those 400 cycles, the batteries don't really die, they just don't have the capacity they used to. In our situation, we measure a battery by whether or not it makes it through a shift. Storing a Li cell in the heat can kill it quickly. Try and use one when it is too cold, and they get lazy giving up their energy. I HATE batteries! Its the biggest pita we have with our courier equipment. Expensive too!

Oh, the 40% charge thing is for long term storage. If you are using your device daily, keep it charged up.

Tony