Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Semi-OT: Painting exterior door

Posts

Semi-OT: Painting exterior door

#1

Semi-OT: Painting exterior door

John T

>Ok - So the wife wanted new carpeting.

This means, of course, we have to repaint.

Different color scheme from the original.....

So, I'm finishing the trim around our entry door - both the trim and the inside surface of the door were initially an off-white, eggshell kind of color, but the new trim is really pure bright white. Trim looks great, but now the door looks dingy.

This is a steel exterior door, facing west, and the outside gets direct sun for most afternoons, and gets hot to the touch some days.

The INSIDE, where I need to paint, stays pretty cool, but is steel (covered by a layer of some sort of paint).

My question is - do I need some sort of special paint for the INSIDE of this door, or will the same semigloss latex enamel wall paint (Behr brand, if it matters) work OK?

Thanks for your ideas.

-John-

Re: Semi-OT: Painting exterior door

#2

Re: Semi-OT: Painting exterior door

Nat Robison

>I've never painted the indoor side of a steel door with anything but interior latex and I've never had an issue. Pro painters might suggest something else but I've never had a problem.

Re: Semi-OT: Painting exterior door

#3

Jason Roehl in Lafayette, IN

Re: Semi-OT: Painting exterior door

Jason Roehl in Lafayette, IN

>Nothing special is needed. Use the same paint on the inside of the door as you did the trim. To be "proper", you should also be painting the strike edge of the door, and the parts of the door jamb that are inside of the weather strip, removing the weather strip if possible for easier painting.

Jason

Addy protocol: pro painter

Re: Semi-OT: Painting exterior door

#4

Thanks Nat and Jason!

John T

>

Re: Semi-OT: Painting exterior door

#5

Dale Lenz

Re: ? Jason

Dale Lenz

>Back in the early 80's I worked for Devoe paint. I would of recommended wiping the metal door down with a product called Pasco. Pasco was advertised as a liquid sandpaper, you had a 30 min. window to paint the metal surface. As I understood it, Pasco let the present paint on the metal surface open to accept another coat of paint, it bonded well. So in your opinion is Pasco another "Slick 50"?.

Re: Semi-OT: Painting exterior door

#6

Jason Roehl in Lafayette, IN

Re: ? Jason

Jason Roehl in Lafayette, IN

>Not necessarily. Pasco, with which I'm not familiar, sounds like a typical paint de-glosser. From what I've read on the cans of de-glossers, they're all pretty much another cocktail of strong solvents--acetone, toluene, MEK, etc., much like some of the other cans you'll find on the same shelf at the store--lacquer thinner, brush and roller cleaner, and so on. They're all slightly different formulations of the same core group of solvent ingredients.

Anyway, I perhaps was remiss in leaving out that step--that the door needs some prep first, be it chemical deglossing, which chemically softens the existing paint and allows for a better bond. I'm not sure whether that sets up a chemical bond, or if it just softens the paint such that the applicator roughs up the paint, leaving some tooth on the surface. Myself, I don't use the de-glossers. I'd rather just scuff-sand. People are more and more leary of any strong chemical smell, so I stick with a once-over of about 150-180 grit sandpaper, then a quick wipe-down with a lightly dampened rag. I can't say I'm fond of using anything with a high VOC content, so I avoid those products like the plague.

Jason