Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Inset Drawer Fix

Posts

Inset Drawer Fix

#1

Inset Drawer Fix

Doug Reynolds in Seattle

>Last year for Christmas, I made a fifteen drawer chest with graduated drawers of flat-sawn cherry. Drawer sides and backs are flat sawn poplar and were built to be the same height as their drawer fronts. Finish is shellac for the interior parts of the drawers. Exterior is Waterlox. The drawers worked fine and this is by far not my first effort. Now the drawers are sticking very badly. I believe the biggest problems are the sides and back and not the drawer fronts. Seattle stays pretty constant in temperature and humidity which is why we have so many stringed instrument makers in the region.

Are there some common guildelines I should adopt when making inset drawers such as: make the back 1/4" shorter than the front and the sides 1/8" shorter than the front. The width of the drawers can be 1/16" narrower than the opening but, the finished drawer front should be X" shorter?

I may just start all over again with some quartersawn stock if only I could find some.

Thanks for your guidance.

Re: Inset Drawer Fix

#2

no need to start over

Bill Tindall, E.TN

>Drawers that are too loose need to be made over. Tight ones just need fitting. It is not clear from your description where the drawer is sticking. In any event find out where and hand plane it to fit. The last chest of drawers I built I fit the drawers three times before everything settled and all was well.

Indeed the back can be left lower than the sides so it does not drag on the dividers. The sides can be 1/16" to 1/8" or so less tall than the opening. The front should be only slightly smaller than the opening at the max of humidity. I make the initial width about the same as the opening and hand plane until it feels about right. Ideally the drawer should slide in easily while pushing on one edge with a finger.

Re: Inset Drawer Fix

#3

Re: Inset Drawer Fix

Tony - Memphis

>I just read an article in FWW by Phil Lowe on drawer making/fitting. Great article. He says to make the drawer boxes 1/16 narrower in the back. Thaat way, you are only fitting the front. Another good tip he offers is to orient your drawer sides when you are building such that you can plane the sides from front to back after assembly (watch the grain).

Tony

Re: Inset Drawer Fix

#4

Re: Inset Drawer Fix

Jerry Samsen

>The trick I learned was that the back of the drawer can be made 1/16" narrower than the front to avoid binding. So the drawer is not really square but is not noticeable.

I would think that height of the drawer sides and front (and maybe back) would have more sensitivity as it is the long grain direction of expansion/ contraction that changes with climate. Not sure what those rules of thumb would be.