Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Precat lacquer finish problem?

Posts

Precat lacquer finish problem?

#1

Precat lacquer finish problem?

DLC

>A few years ago I made a television cabinet using veneered poplar plywood and solids. The poplar plywood was not a furniture grade product.

The cabinet was stained with Bartley Gel Stain and finished with M. L. Campbell precatalyzed lacquer.

Recently, I noticed areas on the plywood top that appear as if the grain of the veneer is raised, i.e., areas with very fine cracks which follow the grain.

The cabinet is in an apartment that is heated with forced air with no humidifier, so the air gets very dry in the winter.

Does anyone have knowledge as to the cause of this?

Thanks for your help.

Re: Precat lacquer finish problem?

#2

Re: Precat lacquer finish problem?

Sgian Dubh

>How many coats did you apply, and how thick was each coat? That may point to the problem.

If you didn't apply as follows that could be the cause.

Pre-cat lacquer should be applied at about 100 microns per wet coat which, when fully cured and the solvents have evaporated, leaves a dry film of approximately 50 microns. Total dry film thickness should be no more than 150 microns. This therefore allows you to put on three coats at 100 microns each. Note: 100 microns is about the thickness of a head hair.

You can also apply two wet coats at about 125 microns per coat leaving a dry film thickness of about 125 microns.

Dry film thicknesses exceeding 150 microns are liable to cracking, usually across the grain, but sometimes with the grain, and in the worst cases it looks like 'Chinese writing'. This is because the finish is relatively brittle and as the upper surface flexes somewhat out of sync with the rest of the film below, stresses build up leading to the cracking. The fault usually appears weeks or months after application, and sometimes grain movement below the film increases the tendency of the film to crack, and in this case my experience is the cracking is more likely to follow the grain. Slainte.

Re: Precat lacquer finish problem?

#3

Ellis Walentine

Loose veneer

Ellis Walentine

>Cracks like you describe are in the wood, not the finish. Whan they peel that veneer, the veneer knife breaks it in a million places, depending on how well prepared the log cant is and what the species is. Dense, brittle woods are more susceptible to cracks.

I guess the answer is to lay the veneer on a stable substrate, and don't allow any original plywood surfaces see the light of day.

Ellis