Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

time to wax after wipe on poly

Posts

time to wax after wipe on poly

#1

time to wax after wipe on poly

Bob in Green Bay

>I have recently finished a piece of work using wipe on poly.

I dug back into the FWW magazines and found that you should wait one month to wax after a petro based sealer is applied.

Gee, I hate to say I can't wait this long, but it seems the poly is good and darn dry (6 coats) after about a week. I allowed 12 hours between coats

Any suggestions here? Will haste ruin the finish? I will use fiddes wax.

Bob in Green Bay - 27 degree last night

sanding will have to soon move indoors.

Re: time to wax after wipe on poly

#2

Re: time to wax after wipe on poly

Chuck in ND

>Poly never needs waxing.

Re: time to wax after wipe on poly

#3

Re: time to wax after wipe on poly

George@Colonel's Workshop-Havertown PA

>Good Evening Bob,

I am not a chemical expert. I do use wiping satin minwax poly the majority of the time on my furniture projects. Generally there are about six coats, applied on successive days, or when I get around to it. I never worry about wax application, because I never had a problem--at least one which I recognized. I like paste wax applied with 4/0 steel wool, which seems to make the satin gloss more mellow. I'm sure more knowledgeable people have good reasons to wait longer. I apply my coat(s) of wax when convenient. So far I received no complaints--and that may be that I only do work now only for me and for my kids. :<)

George

Re: time to wax after wipe on poly

#4

same here

Bill Tindall, E.TN

>I like to "wool and wax" most tops. I never waited that long, but then it is 70 here today not 30's.

The rate of cure for finishes is dependent on temperature. I can scuff sand and recoat a urethane varnish finish the same day when it is in the 80's, while it takes days when it is in the 60's.

Re: time to wax after wipe on poly

#5

Re: same here

al in two rivers, wi

>I have used wax over poly before, and had success. However, you really should wait for a couple of weeks after the poly is on to ensure a good "cure". Remember, poly is cured, not dried, like lacquer or shellac.

Re: time to wax after wipe on poly

#6

Re: time to wax after wipe on poly

Bob in Green Bay

>the poly does seem a little too shiny...I used satin. It seems to make the minor defects more noticeable. A little wax with the wool may tone it down a bit.

I'll give it two weeks.

Even though its cold out - its about 70 in the house, probably in the 60's in the basement

Re: time to wax after wipe on poly

#7

Re: time to wax after wipe on poly

Dave Bair, Eaton Rapids, MI

>I waxed all my kitchen cupboards within a week of the last application of poly. After two years in a fairly tough environment, the finishes look fine. I used Minwax poly and Minwax wax. Wax keeps stuff like syrup or peanut butter from sticking and makes the cabinets extremely nice to the touch.