Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

DC Impeller Questions

Posts

DC Impeller Questions

#1

DC Impeller Questions

Barry Irby

>My DC seemed a little noisier than usual. I pulled the inlet tube loose and looked inside. There was some crud riding on the blades of the impeller. I reached in and cleaned it out. Not much stuff there, but a few long stringy shavings. I notice the vanes of the impeller were very rough. They obviously just stamped them and installed them. Does this matter? Would there be any improvement if I filed or smoothed the edges? Would there be any less tendency for the crud to stick?

Re: DC Impeller Questions

#2

Re: DC Impeller Questions

Chuck in ND

>The impellers are usually balanced. I supose you could file them some, but I wouldn't get too crazy with it. The best way to avoid the crud on the impellers is to put a seperator in before it reaches the DC.

Re: DC Impeller Questions

#3

Re: DC Impeller Questions

Keith Newton------WebKitFormBoundaryV6MZb+tiOpocz6

>There may be other factors more important, like the shape of the blades, but just getting rid of any burrs should improve the flow, by getting rid of some turbulence.

This may not be as important as just keeping the filter clean, but I have seen boats that wouldn't get up on plane due to dings on the leading edge of the prop, that would after fairing the prop.