Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Kinda OT (but not really) Cutting Acrylic

Posts

Kinda OT (but not really) Cutting Acrylic

#1

Kinda OT (but not really) Cutting Acrylic

Tom Rex in TX

>I need to cut a 24� x 24� sheet of acrylic that is 1/32� thick into strips 3� long x 2� wide.

How would you do it?

TIA

T Rex

Re: Kinda OT (but not really) Cutting Acrylic

#2

Re: Kinda OT (but not really) Cutting Acrylic

Bill Earl

>For something that thin, I'd score and snap. There are utility knife blades made for scoring, or you can use a carbide laminate scoring tool.

Re: Kinda OT (but not really) Cutting Acrylic

#3

Jesper, Denmark

Re: Kinda OT (but not really) Cutting Acrylic

Jesper, Denmark

>A negative rake blade on the table saw will work wonders. A standard crosscut or combo blade will also work with a careful feed rate.

A little water cooling from a spray bottle helps a lot. It does not need to be soaked, just misted.

Re: Kinda OT (but not really) Cutting Acrylic

#4

Zero clearance is essential for thin plastic

Keith Newton------WebKitFormBoundaryV6MZb+tiOpocz6

>If you have a TS sled, you can carpet tape a scrap over the slot, so when you cut through, there will be no space for chatter. Use your finest low hook blade with a moderate speed. Too slow will melt the edges, dirty dull blades make it worse.

Re: Kinda OT (but not really) Cutting Acrylic

#5

Re: I agree, use a knife

Brian in Brighton

>

Re: Kinda OT (but not really) Cutting Acrylic

#6

Agree! tape the bottom of each - tho

G Deavers

>This stuff is brittle! SHARP low rake blade as well.

Re: Kinda OT (but not really) Cutting Acrylic

#7

Wear safety glasses

Yonak

>