Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Assembling Plywood Cabinet Sides

Posts

Assembling Plywood Cabinet Sides

#1

Assembling Plywood Cabinet Sides

howard

>what joint type do you use when assembling plywood cabinet sides? I've been using a rabbit on the ends of two panels that accept the other two and are secured by a 15 ga nail from my Senco. Works fine, but just recently noticed a corner separating. Is the standard to use screws, and if so, what type and kind of screw. Thanks for all your comments.

Re: Assembling Plywood Cabinet Sides

#2

Re: Assembling Plywood Cabinet Sides

Tony - Memphis

>I used screws in all my shop cabinets. Just regular McFeeley's. Nothing special. Haven't noticed any issues. I glued them too for kicks.

Tony

Re: Assembling Plywood Cabinet Sides

#3

Re: Assembling Plywood Cabinet Sides

Dick Coers

>Cabinet sides to what? tops, bottoms, face frames, backs, each other?

Re: Assembling Plywood Cabinet Sides

#4

Re: Assembling Plywood Cabinet Sides

Hal Smith

>I use biscuits mostly. Kreg pocket screws would work too.

Re: Assembling Plywood Cabinet Sides

#5

Re: Assembling Plywood Cabinet Sides

Terry in Edmonton

>I glue and clamp well and will use brads, finish nails or #8x1 1/4 screws. The fastener I use is determined by whether it is an inside panel or outside on the string of cabinets and whether they will be visible. Putting the rabbit on the sides and putting the fasteners up through the bottom and down through the top will usually solve the visibility issue.

Re: Assembling Plywood Cabinet Sides

#6

Re: Assembling Plywood Cabinet Sides

howard

>thanks all - I'm going to switch to screws.