Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Will glue stick to a stained surface?

Posts

Will glue stick to a stained surface?

#1

Will glue stick to a stained surface?

Bruce, a MN Galoot

>I'm building a book case for my son, 36" wide and 6' tall, five shelves, face frame, with the bottom three shelves fixed and the top two floating. I would like to at least stain the sucker before I put it together, but am concerned about glue sticking to any stain that happens to get into the dadoes or shoulders. It would be really nice if I could get some varnish on it before assembly, but that's asking a bit much. I don't have spray equipment.

Thanks.

Re: Will glue stick to a stained surface?

#2

Re: Will glue stick to a stained surface?

steve mackay

>Not in my jungle. Not to glue or the marks from those cute plastic clamp pads either. I'm sure its only in my shop though. :)

Re: Will glue stick to a stained surface?

#3

Re: Will glue stick to a stained surface?

Fred Davis

>If you use a water borne Aniline dye for the staining agent you will not have any adhesion problems with a water base glue , like Titebond or Elmer.

A stain agent suspended in a oil base , like Minwax for instance might be a problem.

FredD

Re: Will glue stick to a stained surface?

#4

Re: Will glue stick to a stained surface?

Dave Bair, Eaton Rapids, MI

>Use a water-based dye or use painter's tape to mask off the to-be-glued areas.

Re: Will glue stick to a stained surface?

#5

Re: Will glue stick to a stained surface?

Jesse Cloud

>Sadly, the answer is "If you want it to stick, it won't - if you don't want it to stick it surely will." I would take the advice on painter's tape, though be careful not to cover something that will show after assembly with tape.

Re: Will glue stick to a stained surface?

#6

Re: Will glue stick to a stained surface?

Howard Acheson

>If you are planning to use an oil based stain, the stain will affect the adhesion of the glue. Oil based stains contain a small amount of varnish which will fill and seal the pores. This prevents the proper absorption of the glue. However, if you use a dye stain, the glue joint strength will not be affected.

Re: Will glue stick to a stained surface?

#7

Thanks, guys and

Bruce, a MN Galoot

>darn!

I'm using an oil-based stain to match the other stuff I've made for him. Guess I'll just have to be careful.

Thanks again.

Bruce

Re: Will glue stick to a stained surface?

#8

Re: Thanks, guys and

Jerry Samsen

>I just finished assembling base cabinet and bookcase. I stained using 1lb shellac + oil based gel stain but masked off the edges that were going into dados. Keeping out of the dados was easy.