Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Type of glue to use?

Posts

Type of glue to use?

#1

Type of glue to use?

Edward in Vancouver

>I'm making a chessboard. I've glued 112" x 11/2" blocks of spalted poplar and (some kind of) mahogany together and have bandsawn off 3/16" slices. Both of these woods come from discarded pallets. Obviously my next step will be to glue down the strips to the base--but what kind of glue? What I will be glueing down will be 100% endgrain onto probably 1/2" birch ply.

Granted, there will be no stress or demands on the glued pieces, will normal yellow glue be sufficient? I'm not all that experienced, and don't like contact cement because of the "one shot and one shot only" business. Don't have hide glue--yet, but I can get some, althogh I'd prefer liquid hide glue.

Suggestions?

Re: Type of glue to use?

#2

Yellow

Mark Mandell - Gone Round In Jersey

>Goo would be my choice since it does penetrate the wood, although epoxy would be bullet proof. If (assuming) you'll be banding (framing) the playing grid with solid wood, leave 1/2" reveal on the ply to use as a tenon into the banding boards. Consider a darker wood for the frame like walnut which you may also ebonize with black dye.

Post a pic when you're done

Re: Type of glue to use?

#3

Re: Type of glue to use? *LINK*

C. John Hebert

>I prefer Elmer's yellow wood glue


http://cjohnhebert.com

Re: Type of glue to use?

#4

Elmer's yellow.

steve mackay

>

Re: Type of glue to use?

#5

Re: Elmer's yellow.

Edward in Vancouver

>Yellow it is. Was thinking of using the left over mahognay for banding, but I do have some walnut and teak available.

My firt attempt was using birch veneer, half of it dyed with aneline dye. I used a strip of 11/2" steel as my cutting guide and went at it with an xacto knife. I got the strips fairly straight and accurate, and when I taped the whole thing together, it actually looked pretty good. Then, like a fool I used yellow glue to glue it to the base. Needless to say it wrinkled like an elephant's behind. Tried to iron the wrinkles out , but that didn't pan out.

Mmm.. If I "ebonize" mahogany with a sharpie or black shoe polish, would it be stable under polyurethane or varnish? (I am a bit cheap, don't want to go out and buy black analine dye for 1/8th bd ft of scrap)

Thanks for your advice.

Will try to make an effort to post pics. I stillowe pics of my last project--the LV Tool Chest (qswo) and another smaller toolchest from a woodworking mag)

Re: Type of glue to use?

#6

Re: Type of glue to use?

Dan Donaldson

>I use hide glue for most everything unless it has to be moisture resistant.