Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Hardwood Floor Question

Posts

Hardwood Floor Question

#1

Hardwood Floor Question

Robert Henderson

>My house has hardwood floors throughout (I think they are red oak). The house was built in 1960 and I believe the floors have never been refinished. The finish has worn off in traffic areas and where my cats have thrown up (it's amazing how quickly stomach acid will cut thorough varnish). I have been out of work for 11 months, so renting a sander and refinishing is out of the question until I get work.

I want to attract a paying house-mate, so is there anything I can do as a stop-gap to slow down or stop the degradation and to make the floors look a little better without screwing up my ability to refinish later? Right now I have a lot of time and very little money, so labor intensive solutions are preferred to more expensive ones.

Barring that, can I get away with sanding part of a room at a time with a ROS and refinish piecemeal without making a total mess of the job?

BTW, Does water-based poly do a good job on floors?

Thanks for any help!

Re: Hardwood Floor Question

#2

Re: Hardwood Floor Question

Bricofleur

>Robert,

First, the easy one: Water based poly is great for floors since it gets harder than oil based poly.

The second: If you want to seal the floor until you'll be ready for the complete job, I believe shellac would be the finish to use. It will seal the wood and will be sanded later. Besides that, it's cheap.

Best,

Serge

Re: Hardwood Floor Question

#3

Re: Hardwood Floor Question

Fred Davis

>If you recognize that all floor finishe's will degrade regardless of how easy they are to apply and how hard they cure , then Shellac because of it's easy application and ease of repair becomes far and away the finish for your problem.

FredD

Re: Hardwood Floor Question

#4

Re: Hardwood Floor Question

Nat Robison

>Whatever you do, regardless of looks, shouldn't impede your ability to refinish down the road since you'll be going down to bare wood.

You could probably get away with using 100 grit paper on your ROS to sand the floor but I probably wouldn't put any finish down in stages or it will look like......you put finish down in stages. The actual application of shellac, poly, or whatever you choose actually goes pretty quickly. I did my oak floors with WB poly and a foam roller. All things being equal, I'd pick an oil finish but I needed the ability to do 2 coats in a day.

Re: Hardwood Floor Question

#5

Re: Hardwood Floor Question

Bill White

>Whatever finish you choose, for gosh sakes, use plenty of ventillation. Gassin' yourself ain't fun.

Bill

Re: Hardwood Floor Question

#6

Re: Hardwood Floor Question

Mike Fitterling

>Our heart-pine floors had to be refinished after Hurricane Charlie required a lot of interior repairs. I had previously refinished the floors with oil based polyurethane. After the hurricane repairs the floors were all scratched up. I simply used my vibrating pad sander (one of those little Makita ones) with about 120 grit. I hit all the floor surfaces lightly and reapplied one coat of oil-based poly. The floors looked better than they did after I had first refinished them.

Don't try to just touch up small sections. You will never get the poly to feather out enough on the unfinished sections to look good.

Good luck,

Mike