Re: Dust collection confusion??? Bit long ...
Pete
>I found a used central air vac at a yard sale for $5.00.
I turned it into a cyclone in no time at all. I don't know why folks spend so much money on these incredibly expensive dust systems. Putting this together was *EASY* (with a couple of mis-steps that I'll describe). All you need is a 50 gallon steel drum (with lid), PVC tubing, PVC connectors and PVC glue. For tools, you need a jigsaw with a metal blade (to cut holes in the lid), and a regular saw to cut PVC.
Here is the process:
The basics of the job is to run two pipes into the lid of the steel drum.
- One goes straight down the middle and only extends straight down, just a few inches.
- The second is much closer to the edge of the lid. This one goes in, down a couple inches, then a 90 degree bend.
The first (center) pipe is connected to the vac. The second is split out for your tools. I am telling you, it is easy.
Here are a couple of tips.
- STEEL DRUM - Like an honest to God steel drum. Nothing else will do. I bought a bit aluminum trashcan. Put weather stripping along the lid to provide a good air seal. Crushed it like tin foil. Like I'd stepped on a soda can. Bought one of those heavy heavy gauge cardboard ones. I could lay it on its side and stand on it (230 pounds). The vac just squashed it. Luckily I found a place that brings in flavorings in steel drums and sells them for $17. Even with the steel drum's lid will begin to bow if I close all the seals....
- When running the PVC thru the lid, here is the connection layout. Try to stick with me, cause the description is a bit hard. If you want, let me know, I'll take pictures.
1. Cut two holes in the lid that are the size of the PVC pipe. One hole in the center, one more hole 2 or 3 inches from the edge. I drilled a hole then used a jigsaw. You don't need to make is perfect. You'll seal everything with silicone in the end. But make it pretty close to provide good support.
2. Cut a couple of pieces of PVC pipe that are maybe 3 inches long. These are the sections that will actually sit in the holes.
3. Slide these short PVC pieces into the holes in the lid. On each end place of the short pieces dry-fit / slip on a straight connector (so you will need 4 connectors. 2 for each piece of short pipe). Make certain that these short pieces of pipe are short enough so that when you slide the connectors on each end, each connector can slide all the way to contact the lid. These provide the support that the pipes need.
5. Once you have these dry-fit these, take them apart, apply PVC cement, and put them back together. The lid is nearly done.
6. On the Center pipe, add a 6 or 7 inch section of straight PVC pipe. This will hang down into the center of the drum. All done here.
7. On the Edge pipe, slip a 2 or 3 inch piece of pipe to the connector, and then add a 90 degree elbow. As you are applying the PVC cement twist the elbow so that it runs parallel to the edge of the lid. Not pointed straight way from the center pipe, and not pointed straight at the center pipe. 90 degrees from the center will ensure that as the sawdust is sucked in, it will cyclone around the barrel and fall to the bottom.
8. Just about done. Put the lid on the drum. On the top of the lid, add whatever pipes and make whatever connections you need to get the center pipe to the intake of the vacuum. Make whatever connections, splits, gates, etc. needed to connect the outer pope to your tools.
I ran one along my bench with 3 ports. One for my miter saw, one to clean the bench, one to the floor to pick up sawdust that I sweep at it. I've started one up the ceiling to get to my table saw, but have not finished it yet.
Here are a couple pictures. If you are
