Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

filling grain ?

Posts

filling grain ?

#1

filling grain ?

mike vance

>Planning new kitchen cabs in bubinga. previously, only have worked with oak, birch etc (never have filled grain (pores). want these cabs to look more like fine furniture. plan to joint & plane all boards first. then fill grain with approx 3 coats of shellac, sanding between spray coats. then will cut all pieces (rails/stiles/panels etc. after assembly will spray with lacquer. i may include a mahogany tint/stain to enrich the bubinga before shellac or with shellac. is this sequence ok? again, i've only filled grain on small pieces vs big job, so welcome insight. also if anyone has finished bubinga before, would welcome comments/tips. thanks!

Re: filling grain ?

#2

Ellis Walentine

Bubinga

Ellis Walentine

>Hello Mike. I've finished quite a bit of bubinga over the years, mostly with Waterlox or sprayed lacquer. The wood has pores, but they are very small and not obtrusive, so I never bothered to fill them. If you apply multiple coats of a film finish to the assembled doors, you may find that the pores aren't worth filling. In any case, I'd never recommend pre-filling pores. If you have to level off any joints after assembly, you'll sand right through the pore filler layer of the wood.

Ellis Walentine, host

Re: filling grain ?

#3

Re: Bubinga

mike vance

>Thank you Ellis. I might add that I read your history on AW. I recall with good memories your era there. It was exceptional work. And I remember that gentleman, Jim, too. He also answered so many messages on this board with such a personal touch. I think that is what made yooz guyz so well received in the wood pile, the sense that we were talking with a fellow woodworker over a cup of coffee.