Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Marking Parts In a Project

Posts

Marking Parts In a Project

#1

Marking Parts In a Project

Tom Rex in TX

>What method do you use to identify different parts of your project?

I've tried chalk but it rubs off?

Sticky notes don't stick.

I've used different color markers on unexposed sides of the board but have also marked the wrong place & it's hard to sand out.

I haven't tried blue painter's tape. Have you? How did it work?

Thanks for your suggestions,

Tom

Re: Marking Parts In a Project

#2

Blue Tape

Bill Earl

>I use blue-tape a lot. It is easy to relocate on the part during finishing operations and leaves no residue.

Re: Marking Parts In a Project

#3

Blue Tape is Favorite Method--Also lead pencil

George@Colonel's Workshop-Havertown PA

>

Re: Marking Parts In a Project

#4

Re: Marking Parts In a Project

Clint Searl, at the base of Haycock Mtn

>I hired a crew of Aggies to lay some sod for me, and should have figured out a way to mark it, because I had to keep telling them to keep the green side up.

Clint

Re: Marking Parts In a Project

#5

TAM Class of '70

Mike Caldwell

>Hey Clint,

How long have you been waiting to use that one?!! ;-)

Gig 'em,

Mike

Re: Marking Parts In a Project

#6

Re: Marking Parts In a Project

pecker

>I like to use white Avery labels. Usually 3/4" round ones. They peel off pretty easily afterwards.

Re: Marking Parts In a Project

#7

Re: Marking Parts In a Project

AZ, Colorado Springs

>blue tape & a gel pen -- pencil rubbed off the tape.

Re: Marking Parts In a Project

#8

Ellis Walentine

Pencil

Ellis Walentine

>On complicated projects, I usually had a detailed cut list with each different type of part labeled with a letter, a,b,c, etc. I'd mark those letters on the pieces before I even cut them to length, which was usually the first step. Once cut to length and before jointing and planing, I'd mark the same letter on the endgrain. After jointing and planing and squaring an edge and ripping to width, I'd very often use the old carpenter's triangle method as a quick reference as to how the pieces related to each other -- panel sequences, leg orientations, etc. If there were more than one sub assembly that were the same, I'd add a second (third, whatever) line on one side of the triangle to indicate which assembly it belonged to. When laminating, I would always mark the end of the billet before resawing, with a single cross line and a diagonal. That made it easy to sequence the laminates properly during glue up.

Pencil always worked for me for most layouts. Japanese craftsmen use a bamboo brush and an ink pot called a sumi tsubo, usually carved out of mulberry.

Ellis

Re: Marking Parts In a Project

#9

Re: Blue Tape------WebKitFormBoundaryaT6vsYmfUvr+X

Dave Bair, Eaton Rapids, MI------WebKitFormBoundar

>Actually, it will leave a residue. I found this to be true just last week; it took alcohol, mineral spirits and sanding to remove it from some white oak after an initial fuming with ammonia displayed it.

I have used 1/4" metal stamps, impressed in areas hidden after assembly, to mark mating parts like M&T,s.

------WebKitFormBoundaryaT6vsYmfUvr+XahV