Re: Stickley Table Finished (at long last!)
Frank Mutchler in Colorado Springs
>I have a financial interest in the tool I used to cut all the m&t joints so I want to be careful and not do a drive-by plug. I followed the plan from Robert Lang's book, "Shop Drawings For Craftsman Furniture".
Andy, I planed and scraped to remove all tearout and then sanded to 150. I applied Lockwood dye (Old English Golden Oak) mixed 25 grains to 1 pt. alcohol. Used a shop towel and applied till I thought the color looked right. Then applied a coat of General Finish SealACell followed by a Bartley brown mahogany gel stain as a glaze. Finished by wiping on 2 coats of GF ArmRSeal Satin. The recipe comes from Jeff Jewitt's site.
Ellis, you hit the color perfectly! Thanks very much.
Fred, there are some mistakes but I managed to repair them. This piece is really a 'prototype' for me. I wanted to learn what m&t was all about and also to see if I could actually make the table. I was really surprised when all of those cuts actually lined up where they were supposed to be.
George, the table is 27 x 27 x 29 high. It's a copy of G. Stickley's #516 Table With Open Bookcase. It fits nicely between my recliner & my wife's. I made a lazy susan that raises it about 1/16" off the floor and allows for easy access to all sides. I finally have a table that will hold my laptop and all of my books/magazines that used to clutter up the floor around my chair!
Mike, I think I gave $3.40/bf for the QSWO. Here are some shots of the process:
Cutting a groove for one of the dividers.
Typical joinery for the legs:
The central section dry fit:
Planing up one of the shelves:
Making the dowels for pinning the legs:
Laying out the divider groove in a rail: