Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

OT Cutting tile

Posts

OT Cutting tile

#1

OT Cutting tile

doug f, san clemente, ca

>I have some curves to cut in 1/2" travertine to fit around a medallion in an entryway. The tile saw and an angle grinder work, but not very clean or exact. Is there a way to do the curves with a router and a carbide bit or are there diamond bits for a router?

Any suggestions would be appreciated.

Doug

Re: OT Cutting tile

#2

Re: OT Cutting tile *LINK*

John McGaw

>I haven't tried it but it seems likely that the diamond grinders made for glass working would be great for cleaning up the curve after it is roughed out using other methods. These grinders look very much like a small spindle sander and have interchangeable diamond-coated heads sticking up from a flat work surface. Of course if you don't have and can't borrow on to try out it probably wouldn't be worth it for a one-time job. Especially since this is only a SWAG on my part.


Inexpensive Glass Example (example only)

Re: OT Cutting tile

#3

Re: OT Cutting tile

Clint Searl, at the base of Haycock Mtn

>McMaster-Carr has solid carbide burrs that you can chuck in a power drill that will clean up the rough cut very smoothly in a soft stone like travertine.

Clint

Re: OT Cutting tile

#4

Re: OT Cutting tile

John in NM

>If you have a dremel or similar tool, there are lots of diamond burrs available (Daniel Lopaki Co is a good supplier, though mostly the burrs come from China, so there are lots and lots of vendors). I wouldn't think they're balanced well enough for a router though. Do the bulk of the cutting with a wet saw or grinder, then finish up with the diamond burr.

Travertine is very soft stone, about as hard as steel, so carbide should work ok, but of course won't last as long as diamond. One of those structured tooth cutters would do best I think. Even a high speed steel cutter would make a few cuts before becomming irretrevably dull.

You can do a lot with a wet saw and a light touch, cutting mostly from the back side and sliding the tile sideways against the blade to smooth out a series of kerfs. If the saw is an undertable arbor its a lot easier as you can do all this with the tile right side up, but those saws are usually light and vibrate a lot more than a heavy rolling table saw where you would make the cuts face down and have to cut and look a lot. Either one takes a bit of practice, but its still feasible.

Re: OT Cutting tile

#5

kutzall rasp

Alexander Grigoriev

>

Re: OT Cutting tile

#6

Re: kutzall rasp

Fred Davis

>

Re: OT Cutting tile

#7

Re: OT Cutting tile

Fred Davis

>Remington Arms developed a carbide coated round scroll saw blade tnat would cut your tile like butter.

I have use the jigsaw version for cutouts in tile set in mortar on back splashes, very impressive cut , though slow.

FredD

Re: OT Cutting tile

#8

Wow! Thanks, guys.

doug f, san clemente, ca

>Crack 'o dawn on a Saturday and already I've got some excellent suggestions. This is a great forum!!

Doug

Re: OT Cutting tile

#9

Re: OT Cutting tile

ehgauss

>I've cut curves into ceramic tile using a carbide rod that hooks into a hacksaw frame. I haven't seen them for awhile, but they're just a piece of rod about 3/32" diameter with carbide abrasive adhered to it and loops at each end to hook onto the hacksaw frame. I still have a couple around somewhere.