Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

No More Tipping Trim Router *LINK*

Posts

No More Tipping Trim Router *LINK*

#1

No More Tipping Trim Router *LINK*

Bricofleur

>Trim routers are great tools, but the base is so narrow that they have the tendancy to tip over when milling edges. While one hand holds the router itself and steers, there is not much room to grab the tool with the other hand to hold it flat. And when holding the narrow base, fingers are too closed to the spinning bit!

So, I made this accessory base plate. I used a piece of 3/8"-thick Plexiglass, about 6" by 11". I made it wide enough to give a broader surface, room to place the handles and my hands, but small enough to prevent the Plexiglass from sagging. I used 1/4" fh. bolts and threaded inserts to install the handles, which are 1-1/4" hardwood dowels.

Great tool, great base, great tip !

For more details, pictures and a short video on drilling Plexiglass, click on the following link.

Best,

Serge

http://www.atelierdubricoleur.spaces.live.com


img

Trim Router Sub-base

Re: No More Tipping Trim Router *LINK*

#2

Jesper, Denmark

Re: Machining plexiglas......

Jesper, Denmark

>There are some additional tricks to drilling and machining plexiglas.

It often helps cooling with a water mist or even compressed air, as the plexiglass mets at around 212�F - 100�C. Negative rake angle on cutting tools also is indicated, so a scraping action is used.

Re: No More Tipping Trim Router *LINK*

#3

Re: Machining plexiglas......

Gary Camp, Bend, Oregon

>Not to mention there is plex and plex.My local supplier carries Acrylite CC and FF one has a higher melting point and correspondingly higher price. I use 60 tooth WWII and a fairly fast feed rate cut a few thou over size and clean up with a router for a really clean edge. I have reground drill bits to scrape. I usually buy the cheap stuff

glc

Re: No More Tipping Trim Router *LINK*

#4

Agree completely!

Glenn Madsen near San Francisco

>Which is why, when a bright young newbie, I bought router bases from Pat Warner for my handheld Porter Cable routers and trimmers. Money really well spent.

I'm still not set up to precision cut much plexiglass, although I did a cabinet glazing product with it this summer.

Good idea shown!

Re: No More Tipping Trim Router *LINK*

#5

Re: Machining plexiglas......

Bricofleur

>I'm afraid scraping action will produce more heat. Right?

I will definitely try using compressed air, but not a mist water near the drill press metal parts.

Thanks for the input.

Best,

Serge

www.atelierdubricoleur.spaces.live.com

Re: No More Tipping Trim Router *LINK*

#6

Re: Machining plexiglas......

Gary Camp, Bend, Oregon

>I don't know that a scraping cut drill bit creates that much more heat. They don't try to self feed and crack the plex like a "normal" twist bit does. That said I don't often regrind them for plex. When I do I use a Dremel tool and just "blunt" the cutting edge of bit and put in the "specail" tool box

glc