Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Router Speed

Posts

Router Speed

#1

Router Speed

Tom Rex in TX

>I'm running a 1/2" dovetail bit 1/2" deep in walnut.

What speed should I run my router?

Re: Router Speed

#2

Re: Router Speed

Kneale Brownson..Awaiting return to CO snows

>How about running a straight bit first? Half by Half is a lot of hardwood to be removing in one swipe.

Re: Router Speed

#3

Re: Router Speed

Norh of the Border

>You didn't say what kind of wood. Some softwoods like pine are easy to route. In general, I'd say 16,000 or so but not over 18,000 rpm. As suggested by another poster, it's easier on your bit to route the joint with a straight bit first.

Re: Router Speed

#4

It's Walnut. 16,000 rpm or so shuold be fine.

Norh of the Border

>

Re: Router Speed

#5

Re: Router Speed

Fred Davis

>Using a Keller jig , I just finished 12 drawers dovetailed all around and the 1/2 " x 1/2" is a pretty standard cut that a good router like a Bosch VS has no trouble with one pass cutting.

The wood was Pecan which is considerable harder then Walnut, while the router has a thumbwheel to adjust the speed.

I have learned long ago to listen to the tool while it is running and if it lugs , your running to slow , fast enough to hear no reduction in cutter speed while under load is about right.

FredD

Re: Router Speed

#6

Re: Router Speed

del schisler

>Don't cut or do in 1 pass You can go full speed But Not in 1 pass Take a little off at a time Their should be no problum To slow and you may get burn When you get almost to the 1/2" Take the last pass If any burn is their This should get rid of it

Re: Router Speed

#7

Re: Router Speed

del schisler

>I'm running a 1/2" dovetail bit 1/2" deep in walnut.

What speed should I run my router?

that was in the post

Re: Router Speed

#8

How do you take...

Kneale Brownson..Awaiting return to CO snows

>smaller bites with a dovetail bit?

Re: Router Speed

#9

Miss read post I know better

del schisler

>you don't I miss read i thought a 1/2" round over I don't know where in the hell i got that from I just got back from 10 day's va I have 5 routers and do dovetale's all the time Only speed can be changes I use mine at the fastest and no trouble It is a A10 Box Makers Dovetail Jig - Gifkins Work's very well