Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

plywood blade recommendations

Posts

plywood blade recommendations

#1

plywood blade recommendations

Kelly Anderson

>I will be starting a new project in the next week or two that involves plywood. I generally use my Woodworker II for just about every thing but was thinking that I would like a good plywood blade to help avoid chipping out the plywood. What blade do you use for plywood and how do you like it? Which blade would you recommend for plywood? Thanks for your help

Re: plywood blade recommendations

#2

Re: plywood blade recommendations

Fred Davis

>Kelly, I use a 60 tooth ATB blade , industrial grade for nearly everything but extensive ripping which I use a dedicated TS with a rip blade and stock feeder for.

A good quality 60 -80 tooth ATB will turn out the best cut combined with a zero clearence throat insert you can make or buy.

FredD

Re: plywood blade recommendations

#3

Jesper, Denmark

Re: plywood blade recommendations

Jesper, Denmark

>I have never had any luck with a dedicated plywood blade. They seem to me to just mush trough the plywood, leaving smaller tear-out, but also not as clean a cut.

Re: plywood blade recommendations

#4

Re: plywood blade recommendations

Jim Dillon

>Kelly,

I've had luck with the Forrest Duraline Hi-AT melamine and plywood blade. It is 80 tooth I think and narrow kerf, so I use it with a Forrest blade stabilizer on one side. Worked well on nice veneer plywood, and plywood with formica glued to the top and bottom. But there are likely other quality blades available from Freud, CMT, Tenyru etc.

Jim

Re: plywood blade recommendations

#5

Re: plywood blade recommendations

George@Colonel's Workshop-Havertown PA

>Good Morning Kelly,

I have two Leitz blades, of 60 and 80 teeth which I use. If its critical, I also score the layout line with a knife to insure against tear out. Alternatively, I cover the kerf line with blue tape. Use a zero clearance insert as Fred indicated, as it supports the work close to the blade.

George

Re: plywood blade recommendations

#6

Re: plywood blade recommendations

Michael Dresdner

>I also own a Forrest HiA/T blade, which is made specifically for clean cutting in plywood and laminate, but to be honest, in most cases my well sharpened Woodworker II does a perfectly acceptable job with all but the most persnickety plywood face veneers. In any case, both offer cleaner cuts than the dedicated plywood blades I've tried.

Re: plywood blade recommendations

#7

Re: plywood blade recommendations

Scott Whiting - Glendale, AZ

>I generally use an 80t atb. One thing not mentioned is how important blade height is to the cut quality. If it chips on the bottom lower the blade and if it chips on the top raise the blade.

Scott

Re: plywood blade recommendations

#8

Re: plywood blade recommendations

Kelly Anderson

>Thanks everyone - time to go blade shopping.