Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

First lathe project

Posts

First lathe project

#1

First lathe project

Grant in Iowa

>I know I could post this over on the turning board, but I am not quite ready to take that plunge yet!

Here's my very first (woodworking) lathe project EVER.

The small cup is hard maple and was made by me with no guidance from anyone. Just me playing around with my new-to-me lathe.

The lathe is an old Rockwell 46-111 lathe. While not a ONEWAY, it seems to be perfect for me to get my feet wet in turning.

I wasn't really worried about proportions, but I still think it turned out OK...


img

Re: First lathe project

#2

Re: First lathe project

George@Colonel's Workshop-Havertown PA

>Hi Grant,

Its lovely. Beginner's luck? I don't think so. The proportions look pretty good from here, and so does the finish. I can't tell from the pix, but I bet the thickness is also in proportion. Great job.

George

Re: First lathe project

#3

If I were in your shoes

Bruce, a MN Galoot

>I'd post it on the turning forum. They will gush all over it just like we will. That is a very fine job for a first-time turner, hell, for any turner.

Bruce, whose round things don't look that good.

Re: First lathe project

#4

Re: First lathe project

Grant in Iowa

>Thanks for the kind words, George.

The thickness is under 1/8" until you get to the base. I made it without turning it around in the lathe. Someday I hope to get a chuck, but for now it is faceplates, glue, and a parting tool.

The only experience I have is having looked other bowl turners work.

I can report that the bowl started off shallower, but due to a few minor catches, I had to go deeper. Fortunately, I was wise (or lucky) enough to turn the inside completely before shaping the outside.

Regards,

Grant in Iowa<---FINALLY a day in the shop

Re: First lathe project

#5

Danger, Will Robinson!!!

doug f, san clemente, ca

>Grant - Be afraid, be very afraid!! Once you've tasted the "turning life" it becomes an addiction. Pretty soon you'll be looking at dovetails thinking "How could I do that on the lathe?"

First project or not, you have shown that you have quite a talent for the round stuff. Excellent piece.

Keep up the good work.

Doug

Re: First lathe project

#6

I'm Jealous

Craig in Silverdale

>About all I ever make with my lathe are missiles. But, I can almost aim them now. Very nice job.

Re: First lathe project

#7

Re: First lathe project

John Veerkamp, Western Mo

>Grant,

Come on over to the round side. We're a welcoming bunch. But heed the warnings given!! You'll never go back. Nice piece, especially for a newbie.

John

Re: First lathe project

#8

Pretty doggone good!

Eddie Pacheco; Antioch, Ca.

>Like the others say, come to the turning side. Heck, I sometimes post my stuff there. And it doesn't matter what lathe you have....that's the cheapest part of the whole setup. The turning tools, yeah, that's what gets you.