O.T. Dehumidifier Sizing
Richard Krieger
>Long time....No post....
I recently purchased a Frid.... dehumidifier for our basement. Home is a 9 year old 2,300 sq.ft. ranch with a 2/3 walkout (above grade) basement. There is NOT a severe humidity or moisture problem. We just wanted to keep basement area "fresh" during the summer. Since installing the unit, it "short cycles". No matter what humidity level is chosen, unit will run for about 10-20 seconds, then shut off. Re-start, then run for about 5 minutes. Will "short cycle" again for 2-4 more times, then run for about 5 minutes. Unit is installed with a continuous drain hose. Adjusting the humidity level or fan speed does not change symptoms. If unit was adjusted to 55% level, then immediately turned up to 70%, within 10 minutes, the short-cycling starts in again. Current humidity level is at 65 % with fan speed on LOW. I suspect that the humidistat is defective. It is a 50 pint size. Looking at "on-line" sizing charts, for a 2,500 sq.ft. home with anywhere from a mild to severe moisture problem, anywhere from a 30-45 pint unit is recommended. Why is it "short cycling"????
Any help greatly appreciated...
RLK



