Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Looking for drum sander paper rolls

Posts

Looking for drum sander paper rolls

#1

Looking for drum sander paper rolls

Grant in Iowa

>Hello all,

I have just acquired a Performax 10-20 drum sander, which came with only the installed paper.

I vaguely recall folks here saying that you can save big on the Jet/ Performax pre-cut sandpaper by buying a larger roll and cutting your own.

Two questions:

Which brand and which grits of paper for regular use should be on hand? Where do you order it?

OK, maybe that's three questions...

Regards,

Grant in Iowa

Re: Looking for drum sander paper rolls

#2

Re: Looking for drum sander paper rolls

Dave Paine

>Go to the Marketplace link on Wood Central then the Klingspor site.

You are correct that purchasing a roll and cutting the strips yourself is less expensive.

Klingspor make the abrasive rolls which Jet and others sell as the mfr brand.

I recently purchased the Klingspor Aluminium Zirconia (blue) abrasive. More expensive initially, but does not heat up as much as Aluminium Oxide, does not load up so much.

My results are I get much better use of the Zirconia than AlOxide.

All it takes is one pass to create burn streaks on the roll which can be impossible to remove. Thrown away a lot of AlOxide strips with few passes this way.

Re: Looking for drum sander paper rolls

#3

Re: Looking for drum sander paper rolls

Barry Irby

>I don't have the web sites handy, but try Industrial Abrasives and Klingspor. Klingspor has a consumer division and an industrial side. Stick with the consumer side. One or both of them may advertise here on WoodCentral, so check the ads here.

I am going to buy rolls for my 16/32. I have bought a few from Jet. Not hard to cut them so don't let that stop you. You can save SUBSTAINTIALLY over buying the pre cut rolls. Probably 50% or more, but you have to buy fairly large rolls. Gets into an "investment", but could be worth it. I might limit the number of grits I buy in large quantity. I use 36, 60, 80 and 120 a lot, not so much of 220. You might consider buying some of each and seeing which is worth the investment in larger quantity.

Re: Looking for drum sander paper rolls

#4

Rick L

Re: www.industrialabrasives.com

Rick L

>Better quality and pricing than Klingspor and all the others. Nuff said!

Re: Looking for drum sander paper rolls

#5

Thanks all!

Grant in Iowa

>