Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Jet DC 1200 for small central dc system

Posts

Jet DC 1200 for small central dc system

#1

Jet DC 1200 for small central dc system

Eric Kuehne

>I've found what seems to be a pretty good deal on a Jet 1200 (2hp) dust collector with a Dust Dog filter. My goal is to build a small central system. Max run length would be less than 30 ft with 3-4 elbows. I've done some research on systems but I'm not sure whether this is enough of a collector or not. I've seen the opinions on the really conservative side and respect what I've read but I'm not sure it's a bit over the top for me. Mine is a home shop and I would have no need to run more than one tool at a time. I'm on the fence about whether this would work or I just need a cyclone.

To buy or not to buy. That is the question. Any opinions, experiences or recommendations would be appreciated.

Thanks,

Eric in Los Gatos

Re: Jet DC 1200 for small central dc system

#2

Re: Jet DC 1200 for small central dc system

mike from american sycamore

>this unit will serve you fine! 1200 cfm will be plenty for a home shop! most of your tools have around a 400cfm need and it will also take another 400 to fill your system. you would be able o run two machines at a time without any problems. the biggest drain is right angle turns. locate your unit next to the dirty or highest volum producer such as planer/jointer. This is a good unit and will serve you will. Good luck

Mike

Re: Jet DC 1200 for small central dc system

#3

Re: Jet DC 1200 for small central dc system

Mike Jones in Redding, Ca.

>Eric, if you have expectations that your dust collector will eliminate "dust-in-the-shop" problems by itself you may be disappointed. I have replaced the bag with a shaker felt bag and it has improved it's performance. In my shop, I run an exhaust to outdoors (1200cf/m) and a recirculation air filter to boot. All that and it still doesn't get it all. That said, however, I couldn't imagine being in there without all that to help.

Re: Jet DC 1200 for small central dc system

#4

Re: Jet DC 1200 for small central dc system

Barry Irby

>I agree with both Mikes.

I have a Delta 1 1/2 hp DC that is about 1100 cfm in a small shop and it seems entirely adequate. I ran a six inch PVC S&D plastic main and a number of 4" branches. I occasionally run two tools. Almost none of my tools were set up for DC from the beginning and I had to cobble dust ports together. Absolutely gets 95% of the saw dust. My home made Ambient Air Cleaner gets some more. Still not all of it, but vastly better than nothing. I wonder how I stood it before. I don't have a cyclone to compare it to, but a CFM is a CFM and I doubt a cyclone would do a lot better. I was tinkering with the pickup I put on my contractor's TS trying to improve it from about 95% and a friend who has experience in the industry advised me to give it up. That I had reached the point of diminishing returns and it might actually get worse. I'm at the point that most of the dust in the shop comes from hand tools and hand held power tools and the lathe that are not connected to the the DC. At some point you have to decide whether to do micro clean up or macro clean up. Go for it.