We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
>Just finished applying the last coat of lacquer to this piece of redwood. Still needs to be wooled and waxed. It'll be the top of a coffee table with three legs of textured and colored 5" steel pipe. I hope to have it welded up by next weekend.
This is very nice looking. I have had a redwood burl for over 30 years and never quite knew what I wanted to do with it. How many coats did you put on it? I would like to see the finished product for further inspiration.
>Merle, it has about the equivalent of 4-5 full wet coats to even out the sheen among the flat and end grain areas. I suspect it was cut from a stump or root in a burned over location, as some of the edge looks charred. I used a water white alkyd lacquer from Sherwin Williams to enhance the figure without turning the whole thing muddy, which a penetrating oil would have done.
>Total spray job. After the first wet coat dried overnight, I rubbed down the nibs with 220 drywall screen and brushed the edges with a soft brass brush. Subsequent coats were done in one day, letting each coat harden enough to shave off any pimples with a sharp chisel before spraying the next. The final step was to spray a full wet coat of almost straight reducer to level and even everythin out. In a couple days I'll rub it down with 0000 steel wool lubed with Butcher's wax and buff with old toweling.
I have found that Acetone will remove felt pen ink immediately, if not sooner. *grin*. Just trying to be helpful here....
Regarding spray on Lacquer, seems that the dimpling is common. I was thinking it was just me. I use it on reconditioned saw handles and have tried everything I can think of to get a glass smooth coat without having to steelwool it, but with no success. I usually give it about four coats. That represents a lot of steelwooling.