Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Jointer knife options

Posts

Jointer knife options

#1

Jointer knife options

Joe in a Cleveland suburb

>Hi.

My trusty old (way too small) 6" Delta jointer needs new knives.

Should I buy new ones or have the 3 on the jointer sharpened.

Looking at Holbren Precession Cutting Tools (a WC advertiser) it looks like I can get new T1 HSS knives pretty cheap.

I've had my planer knives sharpened in the past but it doesn't seem like getting these (6" jointer knives) sharpened is worthwhile.

Suggestions? Other options?

Thanks.

Re: Jointer knife options

#2

Re: Jointer knife options

Fred Davis

>Joe,

why do you think a new sharpening would not be a good idea?

FredD

Re: Jointer knife options

#3

Re: Jointer knife options

leadpipe58

>Do both,Have the old sharpened and get a new set.Have a pair and a spair. Sharpin the old set just as good as new.

Re: Jointer knife options

#4

I sharpen my own.....

Barry Irby

>I have an old Rockwell grinder with a micro adjustable sharpening jig on it and use that. I clamp a 12" steel rule in it and adjust the angle. Then I slide the each knife by the wheel. Then I move the slider forward and do it again. I have two sets and sharpen both of them at the same time. I also sharpen my planer knives the same way. Wouldn't be that hard without the micro adjuster.

Re: Jointer knife options

#5

Re: Jointer knife options

Bill Tindall, E.TN

>I like to have two sets of knives. When one is dull I put in the the other set and send the dull ones off to be sharpened. I would suggest only buying American made HSS for best edge life.

Re: Jointer knife options

#6

Re: Jointer knife options

Joe in a Cleveland suburb

>Fred, I didn't know if it would be worthwhile cost-wise.

Thanks.