Festool routers OK?
Jesper, Denmark
>I have a repair job in Germany in a week or so, where I needed a couple of routers for a weird routing operation on some vertical surfaces.
Sionce my shop here is wired for 115 Volt and allthe existing routers are Porter Cable 115 Volt, I needed some that run on 20 Volt and can be repaired or use bits and accessories available in Germany.
Specifically they are a OFK-500 trim router and an OF 1400 plunge router. Other than the bits for the trim router have a weird non-standard method of attachment with a screw down the bit, they seem very handy and well made.
It will be e bit of a triock modifying the trim router bit, as I cannot have the bearing mounted on the bit as I need to use it.
Any comments with these tools from the collective wisdom of the board?



