So I have this Plastic laminate countertop
Glenn Madsen near San Francisco
>Replacing a warped, water and steam damaged IKEA counter top installed a couple three years ago this week. It's cut to length, and I'm dropping the sink into the cutout I'm making now.
It's Home Depot plam, and the substrate is particle board.
What can I do to the cut edges to increase the water resistance?
I have ALEX Plus caulk, and GE Silicone 1 caulk on hand. There's 15 kinds of finish materials in the shop at home, 2 miles away.
This job is too much work for the fun involved. How can I make it stop?



