Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Dewalt 983 cordless drill

Posts

Dewalt 983 cordless drill

#1

Dewalt 983 cordless drill

CG

>The drill started smoking and sparking. You can see it through the venting on the rear of the drill. I've had it for 3-4 years and only done fences, decks and home repair. It's never been dropped nor has it ever been wet or left outdoors. It's a minimum $100.00 charge to have the Dewalt service center just look at it. At the risk of being dumb, is there a maintenence that should have been performed or an easy fix that I don't know about?

Thanks for the help and advice.

CG

Re: Dewalt 983 cordless drill

#2

Re: Dewalt 983 cordless drill

Don J

>No, other than check the brushes. I suspect they are worn down to the wire contacts. Brushes aren't hard to replace if that's the case.

Re: Dewalt 983 cordless drill

#3

Ellis Walentine

Sounds like brushes

Ellis Walentine

>

Re: Dewalt 983 cordless drill

#4

Re: Dewalt 983 cordless drill

del schisler

>take it apart and see what you find It isn't working What do you have to loose Get the experence of what's inside You may find brush's Get them Their may be a trick on keeping them inside the holder and than putting the armiture back into the end again I am sure the repair shop may tell you or you can see what need's to be done Sometine's their is a little hole in the brass holder where the brush's go the you put a very small pin to hold the bursh's in while you install the armiture I done lot's of tune up's on my shop I don't pay anyone to fix drill's saw's ect

Re: Dewalt 983 cordless drill

#5

Re: Dewalt 983 cordless drill

CG

>Thanks all. I really appreciate the help.

CG

Re: Dewalt 983 cordless drill

#6

Re: Dewalt 983 cordless drill

Marv

>If it sounds like the brushes and looks like the brushes and smells like the brushes,,,,,,it must be the brushes.

Marv