Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

HEPA filter with Shop Vac--does it work?

Posts

HEPA filter with Shop Vac--does it work?

#1

HEPA filter with Shop Vac--does it work?

Ron Jones

>Has anyone used a HEPA filter on a Shop Vac? I'm looking at the Shop-Vac 90340 CleanStream Replacement Cartridge Filter to use in cleaning up a storage room in my shop. It may or may not have some nasty dust and other stuff that I would rather not breath or put in the air while cleaning. My theory is it will do little good to vacuum the place if the vac exhausts the dust to settle on other surfaces. My thought was to use this filter with a foam filter (pre-filter) around it to catch the big stuff so that it would drop off the filter when the vac is turned off. I need to keep it portable so the 5 gallon bucket/separator lid concept is not a top choice. Any opinions or suggestions?

Re: HEPA filter with Shop Vac--does it work?

#2

Re: HEPA filter with Shop Vac--does it work?

Bill Howatt

>I have replaced the standard filter in my vac with the pleated paper one which is certainly a lot "tighter". I don't know if it really is a HEPA though. I use the regular shop-vac paper bags with it so all the larger stuff gets trapped in the bag. You are right, whatever gets through the filter system is just blown out into the room.

Bill

Re: HEPA filter with Shop Vac--does it work?

#3

Re: HEPA filter with Shop Vac--does it work?

Barry Irby

>My ancient shop vac has an inlet and an outlet. If yours is similar, you could put a hose on the outlet and extend it outside your shop. Outdoors. That way, any dust would be exhausted out side and less likely to impact your sinus and lungs.

You could also wear personal protective gear. Depending on how bad you think the dust is, you scale up the gear. You could start with a good quality paper mask. Or you could go With a mask with canister filters. Then there is a tyvek suit, etc. Also, you could scale up the vacuum cleaner to one that is really HEPA. If the stuff is really nasty, you should call in the pro's. OTOH, my shop needs cleaning, but it not nasty enough to warrant a space suit.

Re: HEPA filter with Shop Vac--does it work?

#4

Re: HEPA filter with Shop Vac--does it work?

Howard Norman

>I have HEPA filters on both of my Fein vac's. And yes they work, at least on those units.

Re: HEPA filter with Shop Vac--does it work?

#5

JL

Re: HEPA filter with Shop Vac--does it work?

JL

>I have a HEPA filter for my Ridgid. I also have a regular filter. I have also used shop vacuums to clean up really nasty stuff.

Yes, the HEPA filter works as advertised. The regular filter also works well - especially after it has a good amount of "filter cake" on the filter.

If the stuff you are cleaning is particularly nasty, you will need to get rid of your filter (and the foam) afterward rather than continuing to reuse it. Do you want to throw away a nice HEPA filter or an old regular filter?

As suggested previously, depending on the nastiness of the stuff you are cleaning, you may want to wear a Tyvek disposable suit. You probably want to wear an air purifying respirator (either 1/2 face or full face).

Addy protocol: Former environmental hazardous waste chemist who did far too many site cleanups.

Re: HEPA filter with Shop Vac--does it work?

#6

Re: HEPA filter with Shop Vac--does it work?

John McGaw

>I used a CleanStream filter in my old Genie shop vac and the filter itself seemed to do its job very well (the vac itself was rubbish). I have a Fein and have their HEPA filter in it along with using their paper bags. It emits no dust that I can detect. Guess that makes me a believer...

Re: HEPA filter with Shop Vac--does it work?

#7

Re: HEPA filter with Shop Vac--does it work?

Paul Leuba - Hunt Valley, MD

>I have a ShopVac with a HEPA Clearstream filter and with a yellow dust bag rated for fine particles that acts as a filter to contain most of the material before it gets to the Clearstream. The vacuum hose is routed through a 5 gallon Dust Deputy cyclone style bucket that collects 90% of the material before it gets to the ShopVac. I can detect no stray dust emanating from the ShopVac,and the Clearstream filter (pretty expensive) has stayed quite clean. The yellow dust bag in the ShopVac collects almost all the material not collected in the Dust Deputy.

The vacuum available at the hose end is more than sufficient.

Paul in Hunt Valley, MD