Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Another bloodwood question

Posts

Another bloodwood question

#1

Another bloodwood question

Dan Mitchell

>I recently build a table out of hard maple & am planning to apply a bit of bloodwood inlay to the top, comprised of a band about 1.5" wide around the top's outer edge. Last year, I build a box out of poplar as a gift for my MIL, and used another red exotic wood, padouk, to make a handle & feet for the box. Even when there was absolutely NO sanding dust present, I found the padouk bled red badly into the surrounding white poplar when a clear finish was applied. Luckily, I did a test piece & found the problem out before I finished the box itself. So I'm wondering, are there any issues with bloodwood, in terms of finish compatibilities, or bleeding into surrounding wood upon finish application.

TIA

Dan

Re: Another bloodwood question

#2

Re: Another bloodwood question

Barry Irby

>Dan, I can't answer your question, but you might post this over on the turning forum. The people that turn segmented pieces deal with this issue regularly and lets hope well.

Re: Another bloodwood question

#3

Re: Another bloodwood question

Dave Paine

>I have only recently been using Padauk and Bloodwood, startted late last year.

Projects have included Padauk + Mahogoany, Bloodwood + Maple, Bloodwood + Hickory + Lacewood inlay.

When hand sanding the Padauk or Bloodwood with any light coloured wood next to these, I had colour carried over to the light wood.

When using a random orbit sander, attached to vacuum, I had zero issues with dust carryover.

I found when applying hand finish, I could get bleed through from the Padauk or Bloodwood, depending on technique. If the oil was absorbed not an issue, but if not absorved, and my swipe was Bloodwood or Padauk into Maple, some bleed through. If the reverse, no bleed through.

I expect if I had been applying finish via spray, I would not have had a problem.

These are really attractive species in many projects, so I hope you can determine a technique which will allow these to be used without the bleed through.

Re: Another bloodwood question

#4

Re: Another bloodwood question

Bill White

>Seal the oily wood with a dewaxed shellac before installing in the object. It will be a big help. Scrape rather than sand to finished levels.

Bill

Re: Another bloodwood question

#5

Re: Another bloodwood question

Dan Mitchell

>Thanks for the replies. After reading the posts about interlocked grain, I was thinking this wood, while beautiful, might be too much of a PITA, but I think I will give it a try.

I've never used a scraper, if anyone has any tips on which one would be appropriate for this application (a 1.5" band of bloodwood inlayed into a maple top) and possible techniques, I'd appreciate it.

Dan