Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Poplar, limestone and termites.

Posts

Poplar, limestone and termites.

#1

Poplar, limestone and termites.

Basil

>Was flipping through the TV channels today and caught a few minutes of a PBS show, Victory Garden I think it was. Anyway, they were in a cemetary somewhere discussing the tress, tombstones, plots and other stuff. One of the other "Stuffs" was an oak bark sided country cabin modeled after one built for Marie Antoinette(sp?). The cabin was 100 years old and the bark was still good. The caretaker said it had a limestone foundation because termites won't build tunnels accross limestome. And the floor joist and sills were made of Poplar because termites won't eat poplar.

If this is fact, I wonder what's in limestone and poplar that repels termites? And could whatever it is be used to make some kind of safe "natural" or "organic" termite treatment for homes.

Just more useless thinking....but I enjoy it.

Re: Poplar, limestone and termites.

#2

Don't know about the limestone...

John in NM

>But I do know they'll eat poplar! Had a bench in my shop in Tucson that they attacked - legs were poplar. They preferred the mounds of sawdust around the legs, but they definitely ate the legs too.

Limestone is just calcium carbonate, but it tends not to crack as much as other rocks, so perhaps the termites don't find easy access through small fractures and prefer other wood sources where they don't have to build tubes quite as far.

On the whole, I think they just got lucky with that cabin!

Re: Poplar, limestone and termites.

#3

Re: Poplar, limestone and termites.

Alexander Grigoriev

>From what I saw in my 30 year old house (Southern California), the termites will devour yellow wood (pine?), but stay away from reddish doug fir. In one place, one and another were nailed together. The yellow one was pretty much turned into a hole; the reddish was barely touched.

Re: Poplar, limestone and termites.

#4

Re: Poplar, limestone and termites.

Fred Davis

>Redwood was more then likely the "reddish wood" out there .

It was used for framing off and on for years, studs produced were by a stud mill in Blue Lake , ca were called and stamped "four star studs"

FredD

Re: Poplar, limestone and termites.

#5

Re: Poplar, limestone and termites.

Alexander Grigoriev

>I don't think it was redwood.

Redwood is easy to tell from DF. It's more brittle and lighter.

Re: Poplar, limestone and termites.

#6

Re: Poplar, limestone and termites.

Fred Davis

>Well your right about Redwood being distinct in appearence from Doug Fir , but on the other hand .....

Termites in California ,will eat any Cellulose material , regardless of the species.

They don' like Redwood as a rule , but if that's what is avaiable , they do. especially "drywood termites".

There is a Fir out there with Red in it's name, it was called "piss fir" in the trade because of the smell , so the Lumber association started calling it "Western Red Fir", that sounded better.

Carpenters and contractors still call it by it's trade name ;-))

FredD

Re: Poplar, limestone and termites.

#7

Re: Poplar, limestone and termites.

charlie belden

>My father's godfather was an internationally recognized expert on termites. He said that there's very little that'll stop termites - including concrete - slabs or hollow blocks - and even steel. They apparently have a very corrosive saliva. If they encounter something they can't eat on the way to something they can eat, they'll try going over or under it before resorting to going through it.

As for woods they usually pass on - I'm betting that a high resin content wood is low on their choices list.

One thing termites are not fond of is direct sunlight. So a tall foundation, with minimal joints (termite highways) - and some of it exposed before the wood begins may explain why the building has avoided becoming termite dung.

Re: Poplar, limestone and termites.

#8

There you go.

Basil

>High resin content and sunlight.

Here in the south there were a lot of old homes that had stood for years without termites eating them up. Two things made that so, high resin content and sunlight. The old homes were built out of what the old timers called "old original heart pine". That's the type of heart pine that, if ol' Norm ran a board of it accross anything in his shop, he'd have to break out the kerosene and start cleaning his blades. I've pushed up cutoff "heart pine" stumps that have been in the ground well over 150 years and they're still solid. (as a side note here) I tried to make a pin from a root one of those stumps. It was a tight grain swirls of beautiful red and yellow grain patterns. Turned like it was 'wax' and the least amount of heat from sanding it and the sandpaper and wood blank both gummed up and turned black. Not to mention anytime you 'freshen' up this wood it bleeds resin.

Back to subject. Most of the better old homes were built high off the ground on pillars, plenty of fresh air and sunshine under them. Under the houses, the dirt was usually dry as a powder keg. Of course over the years these old homes had some remodeling done to them with southern yellow pine of a ever lower and lower grade. Then came the time that they started "underpinning" these older homes for purposes of heating and 'looks'. Well, then began the termite problems. The termites had dark moist areas to work. They eat up all the newer wood in the homes but they wouldn't touch, or couldn't touch, the older "heart pine".

Back in the 60's when I did carpenter work, it was interesting to gut one of those old homes. When you got them gutted, you could stand back and look at the different methods of construction, wood prep. and quality of materials. It was almost like watching a movie or something on the progression of time. If the home was real old, it might have logs with some hand hewn timbers and split boards. Then you might see some pit sawn stuff, later circle sawmill rough cut, on down to the modern lumber. If there was termite damage, we pulled the modern lumber out by the fist full. The real old wood would still be solid as a rock and the little bit later wood we might have to remove the sapwood and maybe scab some new lumber to it but the newer wood, it usually all had to come out.

Re: Poplar, limestone and termites.

#9

They'll eat throguh just about anything

Mark Goodall - ATL - tooljunkie

>If they chew through pressure treated lumber, drywall, linoleum, etc I would think poplar would be easy/tasty for them. I know they devour poplar trees.

Also, I believe there's a difference between them eating(digesting) something and chewing through something to get to food.

Happy Woodworking!

Re: Poplar, limestone and termites.

#10

I did read a study a few years ago...

John in NM

>That was evaluating a mixture of boric acid and ethylene glycol as a deterrent for formosan termites (they're the worst of the worst as I understand it). It seemed to be quite effective, though unfortunately water soluble so not permanent for exterior applications. The mixture is also an effective treatment for killing mold on wet lumber, though using propylene glycol (Sierra antifreeze for example) instead of ethylene is a good idea if any pets are around.