Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Drawer slides for wide drawers

Posts

Drawer slides for wide drawers

#1

Drawer slides for wide drawers

Bill H - Evansville, IN

>I'm beginning a kitchen island and my wife wants those nice wide deep drawers for her pots and plates. I see that they are manufactured up to 36" wide, but the drawer slide manufacturers seem to say that drawers shouldn't be wider than the slide is long. Is a 36" wide x ~24" long drawer safe w/ a 100 lb ball bearing slide? Or will it rack? Would a slide down the middle help? This seems like a mounting nightmare. Does anybody have any advice or recommendations for products? What do the commercial guys use on the wide cabinets?

Thanks in advance,

Bill

Re: Drawer slides for wide drawers

#2

Re: Drawer slides for wide drawers

Barry Irby

>It's a shame I did not see this question yesterday. I happened to be in a kitchen with very nice cabinets and there were some wide drawers and I could have looked at them closely.

The ones I saw had a single handle mounted in the center of the drawer front. They worked OK, but it might be better to have two handles. Or, maybe not. Now that I think of it, many people might try to open the drawer with one hand and that would automatically try to rack the drawer in the opening. So one good pull in the center might be better. Hmmm?

As a suggestion, I think heavier drawer runners are better than lighter ones. I try to put hundred pound runners on drawers that might have a max of 50 pounds. I think they roll better and smother and last longer. I would suggest going to heavier runners to get sturdier metal parts and better rollers. Undermount runners might give better control over racking.

Re: Drawer slides for wide drawers

#3

Lee Grindinger

Rack em and stack em

Lee Grindinger

>The sizes you list are fine. Use high quality slides and don't leave sloppy side room which is the cause of racking. I made wide drawers and pull outs routinely and using slides that dealt with racking pressures well is the key. Full extension slides are two stage devices and will be more prone to racking than a single stage slide but good ones can easily handle it. I'd also suggest shallow pull outs with sides around 4 inches for the larger drawers rather than high sided drawers, it provides easier access from the side and greater visibility.

Lee

Re: Drawer slides for wide drawers

#4

I have had no porblem

Bill Tindall, E.TN

>Our kitchen has lots of 36" wide pull out shelves behind doors for pots and pans. I used Accuride 100 pound full extension slides(the best in my opinion).

Re: Drawer slides for wide drawers

#5

Re: I have had no porblem

Fred Davis

>Like Bill , I use Accuride , full extension slides for pull out trays located behind double doors.

This works like a charm, saves your wife a lot of leaning over, and I haven't seen a drawer width that side mounted slide couldn't handle.

If you go the tray route , be sure that the tray front extends far enough from the side to cover the slide hardware and prevent it from scoring the inside of the cabinet doors.

I also fur out the the drawer opening so it has about 3/4" clearance on each side , that is before I deduct 1/2" on each side for the slide clearance.

If you want a pic , let me know.

Bottom mount slides are a whole other story.

FredD