Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Finish for Locust outdoor furniture?

Posts

Finish for Locust outdoor furniture?

#1

Finish for Locust outdoor furniture?

Joanne - near Dansville, NY

>I'm building a adirodack chair, ottoman & side table out of locust and I was wondering if I should apply a finish or leave it unfinished? What kind of finish should I use if I need a finish?

Thank your for your comments.

Joanne

Re: Finish for Locust outdoor furniture?

#2

Jesper, Denmark

Re: Finish for Locust outdoor furniture?

Jesper, Denmark

>Assuming this is black locust, Robinia Pseudoacacia, you do not need any finish. It becomes a beautiful light grey that you can keep up with a stiff brush and water.

Re: Finish for Locust outdoor furniture?

#3

Re: It is Black Locust- NM

Joanne - near Dansville, NY

>

Re: Finish for Locust outdoor furniture?

#4

Jesper, Denmark

Re:Then your problem is solved, except......

Jesper, Denmark

>Use bronze or stainless fasteners.

If you have not worked Locust before, you will also get a few surprises - internal stress in boards are common, so binding on the table saw is a potential. The planing can be difficult, as you will experience some wild grain.

If you use screws, dip the screw in linseed oil before you screw them in - otherwise you will not get them out again. Pre-drilling is a must.

The locust is very strong and heavy, so if you use plans designed for pine, you can lighten up on the thickness a bit.