Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Question on TS switch?

Posts

Question on TS switch?

#1

Question on TS switch?

Barry Irby

>I have a Delta/Rockwell from the early 70's. Early in it's life the motor burned up and I replaced it with a Dayton 2 hp TEFC motor. The saw has been 100% reliable. The other day when I flipped the switch (a little toggle switch, not a magnetic one) the blade sort of pulsed and turned less than a revolution and then nothing. I slipped the switch again and it took off. This happened two or three times. Then it went back to being it's old reliable self.

The questions: Was this likely to be the switch or the motor? If (when) it happens again, how do I sort it out?

Re: Question on TS switch?

#2

Re: Question on TS switch?

Randy Johnson Connersville IN

>I'd suspect the switch first.

If it is possible/practicle, get a short piece of wire and short across the terminals on the switch. If the problem can't be repeated it is the switch. If shorting across the switch isn't an option replace it anyway. They are a lot cheaper than a new motor. I would advise upgrading a little on the new switch.

Re: Question on TS switch?

#3

Re: Question on TS switch?

Chuck in ND

>If it's a Delta/Rockwell Contractors saw the first thing I'd do is remove the tiny toggle switch from the cabinet and remove the electrical box inside the cabinet. It's a really poor place for the switch to be, the electrical box fills up with sawdust in time and the tiny toggle switch is hard to find blindly. For about $30 you can buy a large paddle switch from Woodworkers supply, then make a mount from sheet steel and have it in a better location where you easily find it, and it won't fill up with dust. Or if your low on cash and the switch is ok, you can just move it as I described with the paddle switch.


img

Re: Question on TS switch?

#4

Re: Question on TS switch? 

Chuck in ND

>


img