CMS and CMS stands?
JL
>I don't want to have to keep lugging my DW706 over to the playhouse.
It is a stage theatre, so we don't need super accuracy or lots of compound cuts. Realistically, the widest boards that we cut are ~6". The thickest are usually nominally 2". We might occasionally have to cut a 4 x 4 - but not usually.
I was thinking about the Ridgid 12" CMS with a laser (R4121). Then I looked at the Dewalt 10" (DW713). I like Dewalt - I've got the DW706. Do ya'll think I've got to worry about keeping the blades segregated (CMS versus table saw) if I get a 10" CMS?
I also was looking at the Ryobi miter saw stand. It looks very sturdy. I don't/won't have to lug it around, I just want something to crosscut long lumber. This is inexpensive (~$90) and sturdy. Opinions?
TIA



