Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

anyone make an outfeed table for performax 1020

Posts

anyone make an outfeed table for performax 1020

#1

anyone make an outfeed table for performax 1020

-e-

>guess performax as turned into jet, and significantly increased their prices. buying new outfeed table is not in the budget.

so i'm looking to make an outfeed table for my performax 1020 and have been looking online for how others have accomplished this task. however, i've not found much.

i'd appreciate any pictures, plans, references and suggestions on making the outfeed table.

thanks

Re: anyone make an outfeed table for performax 1020

#2

Re: anyone make an outfeed table for performax 102

Barry Irby

>I have a Performax 16/32. I have it mounted on a low roll around cabinet that allows it to park under the wing of my table saw. (Think really small shop) I have a set of rollers in a frame I made out of the rollers in an ancient treadmill. Its a home made version of the rollers companies use to roll packages on. About 14 X 24". I have it at the end of my TS as an out feed table, but it would work just as well for the performax. Have considered remaking the stand for it so that I could use it in both places, but I have not. It would work well. You could also use a slick piece of material like a laminated table top. A slight disadvantage to the solid surface is that it might accumulate crud. In My shop it would be another surface covered with whatever.