Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Frued Router bits

Posts

Frued Router bits

#1

Frued Router bits

Arnold Johnston

>I have recently purchased a FT1702VCEK 2-1⁄4 HP Router with 2 Base Combo Kit. I bought a standard 1/4" keyhole bit from Woodcraft, but it will not tighten down in the collet. Are Frued Routers specific to Frued bits?

Re: Frued Router bits

#2

Re: Frued Router bits

Hal Smith

>The answer is NO. They will handle any router bit. I have a Freud 3-1/4hp mounted in my router table and use all makes of bits. Must admit I've never bought a bit from Woodcraft. My router did not come with a 1/4" collet - just an insert that was a pain in the rear. It was difficult to seat properly and keep in place while tightening. If that is what you have, it may be your problem. I ordered a regular 1/4" collet from Freud and have had no problem. Good luck. Hal

Re: Frued Router bits

#3

Re: Frued Router bits

Lee Schierer - McKean, PA

>My Freud uses any brand bits. Check your collet nut and make sure the insert is fully seated in the nut. The collet should snap into the nut so the nut pulls it out when you loosen the nut. Also make sure you don't stick your bit shanks in so far that ehy bottom out as they will not tighten if they are bottomed out.

Lee

Re: Frued Router bits

#4

One solution

Bricofleur

>Arnold,

I had the same issue with my Hitachi M12V. My solution is to align the full length kerf of the sleve with the full length kerf of the collet. Being in line, you should be able to tighten your 1/4" bits securely.

Be also aware that sometimes cheap bits have smaller shanks. Few thousands can make a difference.

Best,

Serge

www.atelierdubricoleur.spaces.live.com

Re: Frued Router bits

#5

Re: Frued Router bits

Hal Smith

>With all due respect to Lee and Serge, the best solution is to call Freud and order a 1/4" collet.

Re: Frued Router bits

#6

One moresolution

Lee Schierer - McKean, PA

>Freud also makes a 1/4" collet with six fingers for their routers or at least some of them. Get a new 1/4" collet and nut (they are separate parts) from Freud. I have one for mine and it sure beats using a spacer.

Lee

Re: Frued Router bits

#7

Re: Frued Router bits

Charles M

>Please call our parts and repair department at (800) 334-4107 (option 3) and ask for assistance. There have been a couple of instances of 8mm collets being mistakenly included instead of the 1/4" and they can help with the remedy. Sorry for the inconvenience.

Charles M

Freud America, Inc.