Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Steamer

Posts

Steamer

#1

JL

Steamer

JL

>This is my steaming set-up. I built a large one (8' long) for settee backs. I've got a smaller one. It is made of 5/8" exterior plywood. Glued with Titebond water resistant glue and fastened with exterior zinc decking screws. I've got hardwood dowels going from side to side.


img

Re: Steamer

#2

Re: Steamer------WebKitFormBoundaryg+m7FR5DZbDCiSb

Keith Newton------WebKitFormBoundaryV6MZb+tiOpocz6

>That looks pretty good. You should be able to get a lot of parts in there at once. Do you do multiple parts at once?

If you plan to use it in winter, even though it is wood, which is a poor conductor, I would still find a way to insulate it. Steaming is all about getting the wood up around 210� all of the way through. Any heat loss through the walls are wasted BTU's, which makes it take longer.

I have a food thermometer inserted through a hole in mine to monitor the temp in the end of the chamber. But, I have also been thinking about getting one of those which can be inserted into the middle of a thick piece of meat, to insert into a hole drilled into the wood. This would give more accurate information than just going by an hour per inch of thickness.

------WebKitFormBoundaryg+m7FR5DZbDCiSb9

Re: Steamer

#3

JL

Re: Steamer

JL

>We're talking Georgia - it does get down to below freezing up here in the mountains, but not for long :).

I typically steam a couple of parts at a time. If several of us need parts steamed, we have a bending party. It is a lot easier to have more hands to help bang in the wedges or help with the bending.