Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Router speed and speed control Q's

Posts

Router speed and speed control Q's

#1

Router speed and speed control Q's

Ed Wujciak

>I usually hang out in the turning area, but I'm trying to use my router (for the first time in years) and I'm having a problem and I hope someone here can advise. I'm using a 3/16 roundover bit on some cherry. Works fine with the grain, but burns badly when I rout across the end grain. It's a fairly new carbide bit. My router is an older single-speed beast (25K rpm nominal). I seem to remember reading that slowing the router would help. Is this true? I do not have an outboard speed control BUT I do have an old Variac which actually gives me the ability to lower the voltage which will certainly lower the RPM's. Can I use this for a speed control or will I damage the motor? Experiences and/or opinions please. thanks

Re: Router speed and speed control Q's

#2

Re: Router speed and speed control Q's

Bill Houghton, Sebastopol, CA

>Can't help with the speed control question, but cherry burns very easily.

You might try roughing out the rounding (maybe put a little tape on the bit's bearing, if you've got a ball-bearing-guided bit), then routing just a hair off for the finish cut.

Re: Router speed and speed control Q's

#3

JL

Re: Router speed and speed control Q's

JL

>Cherry burns. If you aren't cutting it in the correct phase of the moon and when the stars are correctly aligned - it burns.

Seriously though. I always "sneak up" on cherry. I will do several passes with the last one being whisper thin. I have a container of solvent (usually acetone or denatured alcohol) and I wipe the bit down before the last cut. I have tried varying the speed to a lower and that seems to help also.

Re: Router speed and speed control Q's

#4

Re: Router speed and speed control Q's

Jerry Nicholson

>Using a Variac for speed control for short periods shouldn't damage your router. Running a single speed router at slower speeds reduces airflow and can cause overheating if you do it for too long at a time. That must be one big mama of a Variac if you can run your router on it!

Jerry

Re: Router speed and speed control Q's

#5

Re: Router speed and speed control Q's

Ed Wujciak

>It's a 5 amp variac that I picked up at a garage sale maybe 20 years ago. As a guess, the unit is at least 50 years old. Still works, but certainly doesn't meet current codes or OSHA rules. I use occasionally with great care. The router draws 6 amps (nameplate) but, for short periods, everything works OK. I took all the advice offered above and did a little of this and a little of that. BIG IMPROVEMENT. Thanks to all for the tips.

Re: Router speed and speed control Q's

#6

Re: Router speed and speed control Q's

Bill White

>Sharp bit, small cut, and keep the feed rate up. Don't slow down.

Bill

Re: Router speed and speed control Q's

#7

Re: Question about acetone

North of the Border

>"wipe the bit down" - would you please clarify what you meant by that? And how doing that would minimize the burnout? Thanks.

Re: Router speed and speed control Q's

#8

Re: Question about acetone

Dan Donaldson

>I am going to guess that the wipedown is to make totally sure that the bit has no crud on it and is totally clean for the last cut. Having residue on a blade or cutter can make it burn. You can see it when your saw blades get dirty.