Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

looking for router table

Posts

looking for router table

#1

looking for router table

Jay Cogswell

>I'm looking for a used, stand-alone, router table with good fence and a adjustable lift. The items I find are either the low end (and without lift) and in the $50-$100 range (Craftsman, Bosch, etc.) or high end with precision fence etc, at the $400-$500 range (or more) (Rockler with JessEm-R-Lift). Is it unreasonable to expect to find a good complete package in the $200-$250 range?

Re: looking for router table

#2

Re: looking for router table

Henry (Raleigh NC)

>Jay:

I have not bought a table system, fence, or lift, pretty much for cost reasons. I have cobbled together scraps for table and fence, and change bit height the old fashioned way.

I thought that the lifts themselves are often in the $150-250 range. So without any real data, I would say that yes it would surprise me to find a moderate table with lift in the $250-350 range.

Can you make the table and buy the lift and fence? Depending on the models you choose, I expect that $350 would get you there with that approach.

Henry

hwynands@ieee.org

Re: looking for router table

#3

Re: looking for router table

George@Colonel's Workshop-Havertown PA

>Good Morning Jay,

I suggest building your own table, incorporating design features which you want, such as drawer size/bit arrangement/dust collection configuration, and overall size. That was what I did, since commercially offered tables were way too expensive and generally too small. I subsequently installed a JessEm Mast-R-Lift, which made my P+C 7518 router much more usable. I decided to put on a commercial (PSI)fence on my table because it was relatively cheap and had a good design. I also incorporated an open bottom shelf which supports boxes containing hand-held routers and various bases. I'd allow some extra money, and saving it was surely worth my time and well worthy of the amount finally invested.

George


img

Re: looking for router table

#4

Re: looking for router table

Bill Houghton, Sebastopol, CA

>I'm quite happy with the Hartville fence I installed on a Porter-Cable 698 router table. It took a little finagling (the customer service guy at Hartville talked about "Gyro Gearloose," which, I pointed out, showed both his age and mine, since I knew the cartoon to which he referred), but it works quite well.

I've got probably $100 into the whole table at this point.

I agree: in that price range, build your own, use someone's fence, and adjust the bit height using whatever adjustment your router has.

Re: looking for router table

#5

Re: looking for router table

del schisler

>this is the one i have And it is a good one They have lot's of items also I have boutht lot's of things from them

http://us.oak-park.com/catalogue.html?list=RT01--

Re: looking for router table

#6

Re: looking for router table

Chuck in ND

>I built one, and then bought a router that has above table adjustments. The router, fence, and plate cost me about $450, the stand didn't cost me alot, but I have a considerable amout of time in building it, and it still needs to be takin apart, painted, and reasembled. Build one yourself, and you'll know why no one gives them away.

Re: looking for router table

#7

Re: looking for router table

Greg Young

>As others have said - make one. Use p.lam for the top so it will wear well and incorporate a sliding table so you can end cope etc.

You can cobble together a pretty good fence too.

I still use one I made 20 yr. ago. The big brute of a Porter Cable router is still going too, a few bearings though.