Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Incra jig fence mounting question

Posts

Incra jig fence mounting question

#1

Incra jig fence mounting question

David G. Sparks

>I'm trying to decide where on my router table to position my Incra jig fence. I had to cut a board for the Incra jig to sit on, and the fence is attached to the jig. I need to cut slots in the board and drill holes in my router for the bolts that hold the board down on the table. I know there's a proper place to position the board holding the jig and fence so I'll get the most use from the Incra jig, but I can't quite figure it out. I don't want to drill holes in the wrong place. Thank you for your help.

Re: Incra jig fence mounting question

#2

Re: Incra jig fence mounting question

Dick Coers

>David,

I never did get around to drilling holes to mount my Incra to the router table. I mounted it to a piece of 3/4" melamine, and just clamped it to the table. I thought this would be temporary until I found the best position, but that was about 3 years ago.

Re: Incra jig fence mounting question

#3

Re: Incra jig fence mounting question

David G. Sparks

>Hi Dick,

I did the same thing. I recently improved my router table so the top tilts up for access to the router. I need to mount the fence to the top so I don't accidentally dump it off in the floor. I did find my Incra jig instruction book that gives me some idea of how to position the fence base. Thank you for your help.

Re: Incra jig fence mounting question

#4

Re: Incra jig fence mounting question

Fred Davis

>I mounted the Incra Fence on a Woodpecker brand router table/stand with the mounting board being flush with both ends and one side of the table.

The jig works very well as a router fence and it's micrometer adjustment feature is very handy.

FredD

Re: Incra jig fence mounting question

#5

Thanks, Fred.

David G. Sparks

>

Re: Incra jig fence mounting question

#6

Re: Incra jig fence mounting question

David Lykins -Dallas GA - guitardude

>Hi David, I actually put a couple of the "T" tracks in my router table on each side of the table, parrellel to the left and right side of the router table, about 3-4 inches from the edge of the table. Then I mounted my Incra Fence on a peice of wood, drilled a hole in each side of the peice of wood the Incra fence is mounted on and aligned the holes with the "T" track slots and put two of those "T" track bolts with the screw handle/top to clamp down the router fence. this way you can slide the entire Incra fence closer or farther away from the router bit.

This has worked great for me for the last 6-8 years. Now I need to build a new router table stand though.

Re: Incra jig fence mounting question

#7

Re: Incra jig fence mounting question

David G. Sparks

>Thanks, David. I cut a slot in each end of a board and mounted the Incra jig to it. I drilled a two holes near the back edge of the router table top, one under each slot in the board. I secured the board to the top with blots with plastic knobs on top. I can slide the board all the way back to get full extension of the Incra jig.