Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Recent Project - Liberty Torch display case

Posts

Recent Project - Liberty Torch display case

#1

Louie Lovas

Recent Project - Liberty Torch display case

Louie Lovas

>Hi all, recently finish this display case for my wife. It hold a very old piece of stain glass (about 100 years old) that measures 25" x 12". It's a Liberty Torch that as one of many that was part of the facade of my wife's grandmother's delicatessen in Jersey City. The building was torn down decades ago, just getting around to making the case.

The display case is actually a lighted box, I mounted 3 fluorescent lights in the interior. Two 18" tubes along the sides and a 3" puck in the center behind the (ruby red) flame. I used fluorescent to keep the heat to a minimum, but still vented the interior.

The stain glass is mounted in a frame that's hinged to the box. I also mounted a piece of frosted glass behind it to diffuse the light.

It's mounted on the wall in our dining room (see last pic, with the lights on, looks alot better that the photograph actually). We had an electrician friend wire it in behind (so no dangling wires below) and add a wall switch for it. Now the wife is happy (at least for a while...)

Just thought I would share ...


img

Re: Recent Project - Liberty Torch display case

#2

Very nice

Dan Donaldson

>The backlighting really sets off the glass.

Re: Recent Project - Liberty Torch display case

#3

REALLY BEAUTIFUL - VERY NICE JPB!

Chicago Bob

>

Re: Recent Project - Liberty Torch display case

#4

Very tasty, Louie

Ellis Walentine, Host

>

Re: Recent Project - Liberty Torch display case

#5

Neat project!

Tony - Memphis

>

Re: Recent Project - Liberty Torch display case

#6

Re: Recent Project - Liberty Torch display case

Bricofleur

>This is nice work. Congrats.

I like the bright idea of backing off the glass work with light.

That would be a nice intarsia project too (no light though).

May I add a suggestion: When making the saw kerfs for the corner splines, use a flat bottom tooth blade so you won't get the "ears" from the outer edges of the saw teeth. Or you may file the bottom of the kerfs down.

Best,

Serge

www.atelierdubricoleur.spaces.live.com

Re: Recent Project - Liberty Torch display case

#7

Louie Lovas

Re: Recent Project - Liberty Torch display case

Louie Lovas

>Thanks for the tip on the splines. I use a crosscut blade (ATB tooth pattern) to cut the splines - which clearly leaves those little ears. Never thought to file them away (quite tedious!). Didn't want to use a flat-top rip blade - figured that would increase the likelihood of chip out in the box corners. I did find a flat top crosscut blade from Infinity Tools ...

http://www.infinitytools.com/products.asp?dept=1484

...but the kerf (5/32) was too big for my liking.

I regularly use splines on mitered corners (frames and boxes). For both visual appeal and added strength. For boxes I saw them at a 12 degree angle (love the look), I have a jig that rides on the table saw (in the miter tracks) that cradles the box as it cuts the splines, works really nicely.

thanks again,

Louie