Cutting a newel post....revisited
Ray Carson - Lawrenceville, NJ
>Hello,
A few weeks back I posted a question asking how to cut 1/4 out of a turned store bought newel post. I had a few ideas of my own and received some good advice from some members at WC. Here�s what I came up with.
I made a U-shaped trough or jig with three sides then placed the newel post inside. I placed two cross braces across the top for grab handles and to keep the box from collapsing. The trough was about 8 inches longer than the post in each direction. It�s made of 3/4 plywood. The kerf did close up slightly after removing the post after the first full depth cut. After removing the post and turning it 90 degrees and reinserting it, it opened up. The extra cut in the waste is from my forgetting to allow for the extra 3/4 for the plywood jig. I made 3 passes each side, measuring and raising the blade as I went along. I turned the saw off to measure, of course.
After the trial run on the first post I proceeding with the other three, cutting one side on all the posts to full depth. Repeated the above steps and ran the three again. Worked pretty good.
I know what I did isn�t rocket science, but I thought I�d post this anyway. Maybe it could help someone in the future.
Thanks for looking.
Ray





