Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

back routing

Posts

back routing

#1

back routing

eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---

>I will be routing an oval shape in a board soon. I'm an experienced woodworker, but I am reminded, after all these years and after having performed this operation many times, that it's important to rout "with the grain" , which is to say "down hill" -- the old pet the cat stuff. Ask any turner. Now this would mean that part of the cut would have to be a so-called back route, correct? And now I'm suddenly wondering that even with back routing, the edge of rapidly turning router bit is still going into end grain, which is a potential problem. So what am I missing?

Re: back routing

#2

Re: back routing

Bill Howatt

>I'm not familiar with the term "back route" but you are correct you are going to dealing with end-grain. I had to route the edge of a plaque shaped like a shield (sort of heart shaped) and it drove me nuts. I've never liked routers though!

To go in the safe direction which is the rotation of the bit pushing back, not pulling, gave bad tearout. I had to do climb-cutting which can be a hazard since it can pull the router out of your hand if it catches or shoot the workpiece across the shop if the router is table mounted.

My advice is to use a good quality, sharp bit and take very light cuts.

Bill

Re: back routing

#3

Re: back routing aka climb cutting

Bruce, a MN Galoot

>As Bill says, it can go wrong in an instant, but it gives a cut that is the only way to go when you're cutting against the grain as in the oval you describe.

Take very light cuts, which means don't have the router bit full depth right off the bat. If it takes many passes, so be it.

The result is absolutely no tear-out. It also produces chips that are completely different than those produced when cutting with the grain.

I've done it lots, but I approach it with a great deal of caution.

Bruce

Re: back routing

#4

Re: back routing aka climb cutting

Chris Knob

>I only do the last two very light cuts as a climb cut. If you take too heavy a bite while climb cutting, you will be pulled along by a 12 amp motor with very good traction. I only climb cut to clean up the finish on a routed piece

Re: back routing

#5

Re: back routing *LINK*

Jim Dillon

>Eliot,

Here is a relatively recent WC thread on climb-cutting (what I think you are calling back-cutting) with a router. You might find it of interest.

Jim

http://www.woodcentral.com/cgi-bin/messages3.pl?read=376602


WC thread on climb-cutting

Re: back routing

#6

Re: back routing

eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---

>Thanks for the responses; I didn't realize that this topic had already been so extensively discussed. There is certainly enough information in the link for my purposes, and I will proceed cautiously.