Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Jessem master r slide table

Posts

Jessem master r slide table

#1

Jessem master r slide table

Patrick

>I just recieved my new Jessem cross cut table. I have done the initial installation and have found I have a serious problem. I'm looking for some opinions before I start making modification which will be permanent.

I have a General 650, left tilt, cabinet table saw. It has a HTC fold down outfeed table. The out feed table restricts the tarvel of the Jessem cross cut tabel. This seems to be a problem only when the out feeed table is in the down position (not in use). I don't think one would need to use the cross cut table when the outfeed table is engaged. Other opinions on this assumption would be helpful.

To use the cross cut table when the outfeed table is folded down would require me to modify the out feed table such that the frame structure on the far left side (viewed from the operating the table saw) would have to be cut by about an inch and remove one small roller. It doesn't appear that this would cause any structural damage or weaknees to the out feed table. While this would give the Jessem the needed clearance, this becomes a permanent alteration, and is making me nervous.

It is however, very clear that I would not beable to use both the Jessem and the outfeed table at the same time. Which I repeat doesn't seem to be a problem. Has anyone expiereced this issue? If so, what was your solution.

Re: Jessem master r slide table

#2

Had a similar problem...

Scott in Montana

>Hello Patrick,

I installed a Laguna sliding table on my Powermatic 66 and the only way I was able to use a HTC outfeed table was to buy the HTC table with two rows of rollers. So you may have to change out your outfeed table.

HTC makes this smaller outfeed table to work with their Excalibur sliding table.

Good luck,

Scott in Montana

Re: Jessem master r slide table

#3

Re: Had a similar problem...

Patrick Ramsey

>thanks scott. I didn't know they made a narrower verison. that kind of verifies my thoughts about the modification I'm considering.